设计和实践的电梯控制系统基于PLC外文翻译.doc

电子与信息工程学院 本科毕业论文(设计) 外 文 文 献 翻 译 译文题目： Design and practice of an Eleveator Control System Based on PLC 学生姓名： 刘 中 洋 专 业： 电子信息科学与技术 指导教师： 汪 洋 2013年12月  2008 Workshop on Power Electronics and Intelligent Transportation System Design and Practice of an Elevator Control System Based on PLC Xiaoling Yang1, 2, Qunxiong Zhu1, Hong Xu1 1 College of Information Science Technology, Beijing University of Chemical Technology, Beijing 100029, China 2 Automation College of Beijing Union University,Beijing,100101, China yxl_lmy@ , zhuqx@, Abstract This paper describes the development of 2 nine-storey elevators control system for a residential building. The control system adopts PLC as controller, and uses a parallel connection dispatching rule based on minimum waiting time to run 2 elevators in parallel mode. The paper gives the basic structure, control principle and realization method of the PLC control system in detail. It also presents the ladder diagram of the key aspects of the system. The system has simple peripheral circuit and the operation result showed that it enhanced the reliability and performance of the elevators. Introduction With the development of architecture technology, the building is taller and taller and elevators become important vertical transportation vehicles in high-rise buildings. They are responsible to transport passengers, living, working or visiting in the building, comfortable and efficiently to their destinations. So the elevator control system is essential in the smooth and safe operation of each elevator. It tells the elevator in what order to stop at floors, when to open or close the door and if there is a safety-critical issue. The traditional electrical control system of elevators is a relay-controlled system. It has the disadvantages such as complicated circuits, high fault ratio and poor dependabi