处理量25Th味精废液蒸发系统的设计(含全套CAD图纸).docVIP

需全套CAD或三维图或代码 联系QQ 648328618 摘 要 本课题为处理量25T/h味精废液蒸发系统。采用沸点进料，降膜蒸发的方法。通过物料衡算和热量衡算，确定设计参数和蒸发器的结构参数。此设计是根据各效加热蒸汽消耗量和传热面积进而计算各效蒸发器的直径。另外采用近似比例法计算各效分离器的内径，应用强度计算和水压试验进行校核，接管与筒体之间为焊接。原料液流量为34.1T/h，一效加热蒸汽消耗量为13.83 T/h，蒸发水量为12.67 T/h，二效加热蒸汽消耗量为6.03 T/h，蒸发水量为6.11 T/h，三效加热蒸汽消耗量为6.11 T/h，蒸发水量为6.23 T/h。多效降膜蒸发是将料液自降膜蒸发器加热室上管箱加入，经液体分布及成膜装置，均匀分配到各换热管内，并沿换热管内壁呈均匀膜状流下。在流下过程中，被壳程加热蒸汽加热汽化，产生的蒸汽与液相共同进入分离器，汽液经充分分离，蒸汽进入下一效蒸发器作为加热介质，从而实现多效操作，最后蒸汽进入冷凝器冷凝而液相则由分离器排出。在实际价值方面，多效降膜试蒸发以其独特的换热机理提高了机组的换热效率，做到更小的体积，提高了传热系数和传热效率 ，节约了加热蒸汽 ，适合对热敏性物料生产，在炼乳与奶粉的加工工艺方面具有广泛的应用前景。 Abstract This topic for productivity 25T/h monosodium glutamate wastewater evaporation system. Using the boiling point, and the method of charging flow. Through the material and heat balance, the determination of design parameters and structure parameters of evaporator. The design is based on the effect of the heat and heating steam consumption and calculating the diameter of each evaporator. Another approximate method for calculating the ratio of the diameter, application effect separator strength calculation and hydrostatic test, and between the cylinder for welding. Raw liquid flow to 34.1 T/h ，one effect heating steam consumption for 13.83 T/h , evaporation of water for 12.67 T/h ,two effect heating steam consumption for 6.03T/h , evaporation of water for 6.11T/h ,three effect heating steam consumption for 6.11T/h , evaporation of water for 6.23 T/h . Film evaporation is multi-purpose liquid materials will fall membrane evaporator heating room since joining the tube, the liquid distribution box and film, evenly distributed to each unit of heat exchange tube and tube wall along in a uniform membrane. In the process of flow, shell is heating steam heating vaporization, steam is produced with the liquid into the separators, separation, steam into the next evaporator as heating media, thus realizing the effect of operation, finally steam enters the condenser condensation and liquid by separator. In the practical value of that fil