江淮12变速箱体机械加工工艺及钻左右面孔工序夹具设计（附电子版图纸）.docVIP

江淮12变速箱体机械加工工艺及钻左右面孔工序夹具设计 摘 要 本是12变速箱体加工工艺规程及夹具设计。体零件的加工平面孔系。夹具十分广泛，有着很大的发展空间。机械夹具的要求结构简单，使用方便，制造精度高。夹具选用专用夹具，夹紧方式夹紧，生产效率能够满足设计要求。 The Designing of Process Plan and Fixture for Drilling Holes on Two Face for The JAC 12 Gear Box Abstract This topic is jianghuai 12 variable speed cabinet machining technology procedures and drill face process about fixture design.Processing should pay attention to the plane and hole processing, chronological order.The process route and choose the locating datum is the core content of the process planning. Formulated the process route, Should pay attention to the selection of the locating datum，Especially rough benchmark and the selection principle of pure benchmark. Machine tool selection combination machine tools, For the same type of holes or face can simultaneously processing, Improve the machining efficiency. According to processing need to formulate the process card and process card.Sure every process equipment, tooling, process headroom, cutting dosages, spindle speed parameters. The application in machining fixture is very extensive, Have a very big development space. Mechanical fixture is requirements of simple structure, Easy to use, manufacturing precision is high. This topic chosen fixture are special jig.Clamping means uses hydraulic clamping, Compared with pneumatic clamping many advantages, To increase the production efficiency, Easy to realize automation clamping, This topic fixture design can satisfy the design and processing requirements. Key words: Procedure; The process route; The process card; Process card; Jig; Hydraulic clamping; automation 目 录 引 言 - 1 - 绪 论 - 2 - 第1章 零件的工艺分析 - 4 - 1.1零件的作用 - 4 - 1.2 零件的工艺分析 - 4 - 第2章 工艺规程设计 - 6 - 2.1 确定毛坯的制造形式 - 6 - 2.2 定位基准的选择 - 6 - 2.3 制订工艺路线 - 6 - 2.4 机械加工余量、工序尺寸及毛坯尺寸的确定 - 9 - 2.5确定切削用量及基本工时 - 12 - 第3章 夹具设计 - 30 - 3.1 夹具设计 - 30 - 3.2 定位元件的设计 - 31 - 3.3 钻套、衬套和钻模板的设计 - 32 - 3.4 定位误差分析 - 33 - 3.5 夹具设计及操作的简要说明 - 34 - 结论与展望 - 35 - 致谢 - 36 - 参考文献 - 37 - 附录 - 38 - 附录A 外