宁武县第一热源厂供热工程设计（附电子版图纸）.docVIP

需全套CAD或三维图或代码 联系QQ 174320523 宁武县第一热源厂供热工程设计 摘 要 本次设计为宁武县第一热源厂供热工程设计。 首先进行了热区划分，选定热负荷指标并确定了供热区域的热负荷，锅炉房及其厂区位置，换热站位置、规模和数量，由此确定了一次管网路由。一次网采用无补偿直埋敷设。本设计对一次管网进行了水力计算，绘制了管网水力计算简图和水力计算表，另外还对直管、弯管等进行了应力验算，对热伸长进行了处理。 其次进行了换热站的设计，选取1#换热站，根据供热区域热负荷确定了换热器的型号和台数。同事，对辅助间设备进行了设计计算与选择，包括循环水泵的选择与计算；补给水泵的选择与计算；软化设备、除氧设备的选择与计算；除污器、水箱、分集水器的选择与计算。另外确定了热源调节方案；各管道管径等。 最后进行了煤粉锅炉房的设计，先选择了锅炉房的燃料，进而确定了锅炉型号与台数。同时，对送、引风系统和水处理设备进行了选择和计算，包括除尘器的选择；烟囱的设计计算；循环泵的选择计算；补水泵的选择计算；软化设备的选择计算；除氧设备的选择计算；除污器的选择等。 关键词：煤粉锅炉、一次网、换热站、直埋 The design for Ning Wu Xian first heat source factory heating engineering design Abstract The design is for Ning Wu Xian first heat source factory heating engineering design. Firstly, the design carried on the hotspot, heat load selected indicators and determine the heat load of heating area, boiler room and factory location, so the heat exchange station location, size and quantity, determine the pipeline route at a time. A network using directly buried installation without compensation. The design of a pipe network hydraulic calculation, draw a diagram of hydraulic calculation and hydraulic calculation table, also on the straight pipe, pipe bending stress calculation, thermal elongation for the processing. Secondly, the paper gave the design of the heat exchange station, selection of 1 # heat exchange station, according to the heating area heat load models and the Numbers of the heat exchanger. Colleagues, between the auxiliary equipment for the design calculation and selection, including the selection of circulating water pump and calculation; Supply water pump selection and calculation; Softening equipment, the selection and calculation of oxygen removal equipment; The decontamination device, water tank, the selection and calculation of the diversity is. In addition to determine the reservoir regulation scheme; The pipe diameter, etc. Finally, it carried on the pulverized coal fired boiler room design, first select the boiler fuel, then determine the boiler model wi