止转垫板冷冲压工艺及其连续模设计论文（含CAD图纸全套）.doc

买文档后送图纸，QQ 194535455 摘 要 对进行的模设计，利用软件对件进行。明确了设计思路，确定了成型工艺过程并对各个具体部分进行了详细的计算和校核。如此设计出的结构可确保模具工作运用可靠，保证了与其他部件的配合。绘制了模具装配图和零件图。关键词：冲压 Abstract The design for a locking plate of cold stamping die design, according to the size of the design components, materials, mass production, etc., the first part of the process of analysis to determine the blanking process planning and die structure of the program, and then through the process design calculations, determine the nesting and cutting board, calculate the pressure and pressure washed centers, primary presses, computing convex and concave Die Cutting Edge dimensions and tolerances, the final design selection of parts and components, to press for checking, drawing die assembly drawings, as well as Mold processing technology of the main parts to the preparation procedures. In which the structural design, primarily to the punch and die, punch and die, positioning parts, unloading and out of pieces of equipment, mold, pressing equipment, fasteners, etc. has been designed, for the selection of some components are standard parts , there is no in-depth design, and structural design, while some parts for the processing process analysis and ultimately to complete this graduation project. Progressive die design of the locking plate is, to design parts drawing using CAXA softwere. Defined the design, determine the stamping forming process and the detailed calculation and test for each specific parts. So the structure is designed to ensure reliable mould work, ensure the cooperation with other components. And to draw the mold assembly drawing and parts drawing. Key words: Locking plate; Staming process; Stock layout; Progressive die 目 录 要 III Abstract IV 目 录 V 1 绪论 1 1.1本课题的研究内容和意义 1 1.2国内外的发展概况 1 1.2.1 国外模具发展概况 1 1.2.2国内模具发展概况 2 1.3本课题应达到的要求 3 2 冲压工艺设计 4 2.1 冲压件简介 4 2.2 冲压的工艺性分析 4 2.3 冲压工序 5 2.4冲裁间隙 5 2.5 冲压工艺方案的确定 6 3 止转垫板连续模设计 7 3.1 模具结构 7 3.2 确定其搭边值 8 3.3 确定排样图 8 3.4 材料利用率计算 9 3.5 凸、凹模刃口尺寸的确定 9 3.5.1 落料部份凸、凹模刃口尺寸的确定 9 3.5.