轴承内外圈加工专用机床横向机构设计（含CAD图纸全套）.doc

买文档后送图纸，QQ 194535455 摘 要 本文是根据无锡迪奥机械厂轴承内外圈生产线改造项目要求，针对横向部分能自动实现进给，快退，自动感应识别运动位置等要求，设计出一套轴承内外圈专用机床横向进给机构，使其能够代替工人手动进给，提高了公司生产效率。 论文根据轴承内外圈的特点，对其横向进给机构进行了合理的设计。此横向机构主要为了实现台面板上的刀具在切削轴承内外圈横向进给的运动。这一运动由阻尼液压缸驱动，由PLC控制，由感应元件识别确认台面板横向进给时的位置。本文要设计的内容主要包括：阻尼液压缸驱动系统的设计，床身钳尺寸的确定，滚珠丝杠的设计，台面板的设计等。确定了横向进给机构的具体尺寸后，利用UG软件对横向机构的主要部件进行建模，并对整体结构进行虚拟装配。然后将装配体导入UG软件的运动仿真界面，并利用软件进行运动学仿真和动力学仿真。分析仿真结果，得出相应结论。最后对轴承内外圈加工专用机床横向机构进行优化设计，让本设计能够真正的投入到日常生产操作中，使其切实能够为轴承厂的生产线改造做出贡献。 关键词：进给机构；轴承加工；虚拟装配；运动仿真 Abstract This paper is based on the reconstruction project requirements of the inner and outer circle line of bearings in Wuxi dior machinery factory. In order to achieve the requirements that the horizontal section automatically forwarding and identifying locations, this article designs a set of bearing internal and external ring special machine transverse feeding mechanism. It’s a special machine tool be used to replace workers manual feed and improve the companys production efficiency. According to the characteristics of the bearing inner and outer circle ,the article designs its traverse mechanism reasonable.This mechanism mainly achieve the cutting tool on the the panel in cutting of bearing transverse feed motion on the inside and outside the circle .The movement is driven by damping hydraulic cylinder, controlled by PLC, recognized by the sensing element identification to confirm the position of the panel. The content of the article mainly includes damping hydraulic cylinder driving system designing, the determination of lathe bed clamp size, the design of the ball screw, a panel designing, etc. After determining the specific size of the infeed mechanism, the article applies UG software to model a major part of the traverse mechanism and assembly its overall structure virtually. Finally, the design of the machine infeed organization is optimized, so that it can really be used to put into the day-to-day production operations and make contribute to the production line of bearin