E-Sys系统-入门编程-1.pdfVIP

E-Sys v3.18.4 Getting Started: Coding EST Token Required Ethernet to OBDII cable Build cable as per enet_doku.pdf found in C:\EDIABAS\Hardware\ENET Read both PDF documents as they are useful and tell you how to edit eidabas.ini and troubeshoot Step 1: Connect cable to computer then to car Step 2: Wait till LAN network adapter in task bar has established limited network capability (no screenshot) Step 3: Open ZGW_SEARCH.exe Step 4: If cable is built correctly, and EDIABAS.ini is configured correctly you should get (see screenshot) Information Masked for privacy Note: If it is BLANK, it’s likely due to the LAN connection is still configuring, wait until it has shown Limited Connectivity and hit refresh If you get an error, verify cable is connected to both computer and car Further information read Anleitung EDIABAS-Ethernet.pdf found in C:\EDIABAS\Hardware\ENET Step 5: Open E-Sys Step 6: Click the Connect button Step 7: Select F series you are working on, my case F10 and select Connection via VIN and click “Connect” Step 8: Click “OK” Step 9: Click “Read” Note: Option to save or not to save Step 10: Click “Read (VCM)” Step 11: Select CADF (only one with a green Check mark) file under the module you want to read and select “Read Coding Data” Step 12: Error Report, Click “Close” (or save if necessary) Step 13: New option under CADF, a folder. Expand the folder by clicking + and right click that file, Select “EDIT FDL” Step 14: Browse the folders till you find your option, I want option KOMFORTSCHLIESSUNG_FB Step 15: Factory option set to nicht_active. Right click, select “Edit” Step 16: Select option desired, in this case,