基于两套网格CA方法模拟铸造镁合金凝固过程枝晶形貌演化.pdfVIP

45 12 Vol.45 No.12 2009 12 1414—1420 ACTA METALLURGICA SINICA Dec. 2009 pp.1414–1420 CA ∗  (, , Æ 100084) (CA) , ℄. ℄ , , ℄Æ; , ℄ CA ℄, . , Æ. ℄ ℄ AZ91D Mg–10Gd–2Y–0.5Zr( , %) . AZ91D Mg–10Gd–2Y–0.5Zr . , , , , 111.4 A  0412−1961(2009)12−1414−07 MODELING AND SIMULATION OF MICROSTRUCTURE EVOLUTION OF CAST MAGNESIUM ALLOYS USING CA METHOD BASED ON TWO SETS OF MESH HUO Liang, HAN Zhiqiang, LIU Baicheng Key Laboratory for Advanced Materials Processing Technology, Ministry of Education, Department of Mechanical Engineering, Tsinghua University, Beijing 100084 Correspondent: HAN Zhiqiang, associate professor, Tel: (010 E-mail: zqhan@tsinghua.edu.cn Supported by National Basic Research Program of China (Nos.2005CB724105 and 2006CB605208) and National Natural Science Foundation of China (No Manuscript received 2009–05–06, in revised form 2009–10–18 ABSTRACT The texture of Mg alloy dendrites is quite different from that of fcc or bcc metals because of the influence of hcp crystal lattice on the dendrite morphology evolutions during solidifica- tion. Although the simulations of dendrite morphologies for fcc or bcc metals by cellular automaton (CA) methods have been widely reported, CA simulations of magnesium alloys with hcp crystal lattice have just appeared in recent years. When performing the simulation of Mg alloy dendrites with a CA method on a square mesh, the artificial anisotropy of growth kinetics introduced by the square mesh makes it hard to reflect the texture of Mg alloy dendrites, which shows the six–fold symmetry instead of