多路温度采集系统程序.docVIP

主机程序 #include reg52.h sbit RS=P2^5; sbit RW=P2^6; sbit EN=P2^7; sbit E=P2^3; void master(void); unsigned char cort=0; unsigned char table1[]=111111; unsigned char table2[]=111111; unsigned char table3[]=111111; unsigned char table4[]=111111; unsigned char num=0; Delay(unsigned int i) { while(i--); } void delay_50us(unsigned int t) { unsigned int j; for(;t0;t--) for(j=19;j0;j--); } void write_com(unsigned char com) { EN=0; RS=0; RW=0; P1=com; delay_50us(10); EN=1; delay_50us(20); EN=0; } void write_data(unsigned char dat) { EN=0; RS=1; RW=0; P1=dat; delay_50us(10); EN=1; delay_50us(20); EN=0; } void init_1602(void) { delay_50us(300); write_com(0x38); delay_50us(100); write_com(0x38); delay_50us(100); write_com(0x38); write_com(0x08); write_com(0x01); write_com(0x06); write_com(0x0c); } void main() { unsigned char j; unsigned char i; unsigned char k; unsigned char t; TMOD=0x20; TH1=0xcc;//波特率600 TL1=0xcc; TR1=1; SCON=0xf8; EA=1; PCON=0x00; EX0=1;//外部中断0允许 IT0=1;//外部中断0下降沿触发 E=1; init_1602(); delay_50us(2); while(1) { //从机一// write_com(0x81); for(j=0;j6;j++) { write_data(table2[j]); } Delay(200); if(cort==1) { SBUF=0X01; while (TI!=1);TI=0; E=0; SM2=0; Delay(2000); for(num=0;num6;num++) { while(RI!=1);RI=0; table2[num]=SBUF; } SM2=1; E=1; } //从机二// write_com(0x80+0X41); for(i=0;i6;i++) { write_data(table1[i]); } Delay(2000); if(cort==2) { SBUF=0X02; while (TI!=1);TI=0; E=0; SM2=0; Delay(200); for(num=0;num6;num++) { while(RI!=1);RI=0; table1[num]=SBUF;