水源热泵机组台数配置及能耗分析.pdfVIP

水源热泵机组的台数配置及能耗分析 1,2 2 2 赵强 ,陈海锋 ,黄体士 1 山东省煤田地质局山东亚特尔集团股份有限公司,济南,250011; 2 山东方亚地源热泵空调技术有限公司,济南,250010 摘要 本文提出了一种水源热泵机组配置分析方法，针对某一实际工程，基于详细的全年逐时负荷数据，对 负荷分布频率和负荷权重进行热泵主机负荷率和能耗计算分析，为水源热泵机组的台数优化配置和控制策略 提供了合理的依据。在系统中仅配置一台热泵主机不利于该系统部分负荷条件下的节能运行。多台热泵联合 运行和容量不对称的配置原则，有利于系统部分负荷条件下每台机组的部分负荷权重向满载靠拢。尤其是当 系统配置两台热泵机组时，不对称的设计原则，采用 1:0.6 的配置模式，是一种降低系统能耗的必要手段。 关键词 分布频率，负荷权重，负荷率，能耗分析 Configuration Analysis and Energy Consumption Calculation of Water Source Heat Pump Units 1,2 2 2 Zhao Qiang ,Chen Haifeng , Huang Tishi 1 Shandong Yateer Group Co. Ltd. Shandong Coal Geological Bureau. Jinnan. 250011; 2 Shandong Fangya GSHP Technology Co. Ltd. Jinnan. 250010 Abstract: The present paper proposes a configuration analysis method of water source heat pump units (WSHP units). Selecting a practical project as the sample, calculation and analysis of the unit’s load rate and energy consumption provide reference for optimal allocation and control strategies of WSHP units based on detailed hourly loads. A heat pump unit only configured is not conducive to energy-saving operation in case of part load conditions. Multiple units and principle of capacity asymmetry benefit that unit’s part load weight close to full load in case of part load conditions. When the system is allocated with two sets of heat pump unit, design principle of capacity asymmetry and the mode of 1:0.6 is a necessary means to reduce energy-consumption. Keywords: distribution of load share, load weight, load rate, analysis of energy consumption 0 引言 调系统的冷热源，水源热泵机组的配置原则，牵扯 地源热泵空调系统利用大地中的低品位热能来 到压缩机类型、供回水温度额定参数、制冷（热） 实现对建筑物的供热供冷，具有节能与环保的优点