思科2.6.docVIP

1 窗体顶端 Refer to the exhibit. Which address is a broadcast address for one of the subnets that are shown in the exhibit? 192.168.4.3/29 192.168.4.15/29 192.168.4.65/26 192.168.4.255/24 窗体底端 2 窗体顶端 Refer to the exhibit. The number of required host addresses for each subnet in a network is listed in the exhibit. This number includes the host address requirements for all router ports and hosts on that subnet. After all device and router port address assignments are determined, what will be the total number of unused host addresses available? 6 14 29 34 40 62 窗体底端 3 窗体顶端 Refer to the exhibit. In the network that is shown, the router interfaces are assigned the first address in each subnet. Which IP address would be usable for a host on one of the LANs in this network? 192.168.1.5/30 192.168.2.17/28 192.168.2.63/27 192.168.2.130/25 窗体底端 4 窗体顶端 Refer to the exhibit. What subnet mask will be applied by router B when it receives a RIPv1 update for the network 172.16.1.0? none 8 16 24 窗体底端 5 窗体顶端 Refer to the exhibit. The network administrator wants to minimize the number of entries in Router1’s routing table. What should the administrator implement on the network? VLSM CIDR private IP addresses classful routing 窗体底端 6 窗体顶端 Which three interior routing protocols support VLSM? (Choose three.) OSPF RIP v1 RIP v2 EIGRP BGP STP 窗体底端 7 窗体顶端 What does VLSM allow a network administrator to do? utilize one subnet mask throughout an autonomous system utilize multiple subnet masks in the same IP address space utilize IGRP as the routing protocol in an entire autonomous system utilize multiple routing protocols within an autonomous system 窗体底端 8 窗体顶端 A Class C address has been assigned for use in the network shown in the graphic. Using VLSM, which bit mask should be used to provide for the number of host addresses required on Router A, while wasting the fewest addresses? /31 /30 /29 /28 /27 /26 窗体底端 9 窗体顶端 Which of the following problems d