（毕业设计）论文）_云南滇东4×600mw新建工程烟气脱硫项目设计.docVIP

云南滇东4×600MW新建工程烟气脱硫项目设计 摘 要 本设计针对所给出的烟气含量和脱硫要求，结合我国烟气脱硫的技术现状而设计出的一套烟气脱硫系统。湿法石灰石－石膏法烟气脱硫×600MW new construction design of Flue Gas Desulphurization projiect In Easten Yunnan Abstract This design according to the given power of Easten Yunnan manufactory flue gas content 、limestone composition and dust removal and desulfurization requirements, combined with the flue gas desulfurization and dust removal technology situation of a set of flue gas desulfurization denitration system. The major work for this design：Introduces several flue gas desulfurization technologies, chooses proper FGD process for this project after comparing merits and drawbacks of several major dust removal and flue gas desulfurization technologies. Finally, we applied the wet limestone-gypsum flue gas desulfurization process. This design is to introduce the system of dust removal and desulfurization process of each subsystem and equipment layout. As for the FGD system, mainly introduces the process and facility arrangement of subsystems in FGD system, and they are respectively the system of limestone slurry preparation, gypsum treatment system, adsorption system, system of flue gas and wastewater treatment system. At the end of this design, it makes some comprehensive analysis of the whole system designed , and makes some engineering budgetary as well as some simple economic and technical analysis. Keywords: wet limestone - gypsum and scr.some method, flue gas desulfurization and denitration main equipment 目 录 摘要 I Abstract II 第1章 绪论 VI 1.1 烟气除尘脱硫的背景 VI 1.2 烟气脱硫的目的及意义 VI 1.3 课题研究的主要内容 VII 第2章 工程概况 VIII 2.1 电厂概况 VIII 2.2 烟气参数 VIII 2.3 石灰石参数 VIII 2.4 总体设计原则 IX 第3章 烟气脱硫工艺的选择 XI 3.1 几种常见的脱硫工艺 XI 3.1.1 石灰石-石膏湿法脱硫工艺 XI 3.1.2 旋转喷雾半干法烟气脱硫工艺（LSD法） XII 3.1.3 炉内喷钙加尾部增湿活化工艺（LIFAC法） XII 3.1.4 烟气循环流化床脱硫（CFB）工艺 XIII 3.2 脱硫工艺比较 XIV 3.3 脱硫工艺的确定 XIV 3.4 本设计采用的脱硫系统 XV 3.5 石灰石-石膏湿法烟气脱硫工艺系统 XV 3.5.1 烟气系统 XV 3.5.2 SO2吸收系统 XVI 3.5.3 石灰石浆液制备系统 XVI 3.5.4 石膏脱水系统 XVI 3.5.5 供水和排放系统 XVII 第4章 物料平衡计算 18 4.1 除尘、脱硫效率的计算 18 4.1