变压器一次接线组别对二次差动保护接线方式的影响.pdfVIP

DOI:10.13648/ki.issn1674-0629.2010.03.005 2010 年 第 4 卷 第 3 期 南 方 电 网 技 术 实践与经验 2010 ，Vol. 4 ，No. 3 SOUTHERN POWER SYSTEM TECHNOLOGY Practice Experience 文章编号：1674-0629 (2010)03-0096-03 中图分类号：TM403 文献标志码：B 变压器一次接线组别对二次差动保护 接线方式的影响 王轶 （广东电网公司坪石供电局，广东 韶关 512229 ） 摘要 ：针对一起Y/d －11 接线组别的变压器差动保护二次误接线进行分析。变压器Y 侧一次绕组电压相位与d 侧一次 绕组电压相位存在相角差，导致变压器两侧一次电流存在相角差。因此参照 d 侧一次绕组的联结方式对差动保护的 Y 侧电流互感器二次绕组进行三角形变换，以消除一次相角差的影响，保证差动保护的二次接线方式正确。 关键词 ：变压器；一次接线组别；二次差动保护；接线方式 Influence of the Primary Wiring Connection Mode of Transformer on the Connection Mode of Secondary Differential Protection WANG Yi (Pingshi Power Supply Bureau, Guangdong Power Grid Corporation, Shaoguan, Guangdong 512229,China) Abstract: Analysis is carried out based on a misconnection fault of secondary differential protection of Y/d-11 wiring category transformer. It is found that there is a vector difference between the voltage of Y-side primary winding and that of the d-side. Therefore, there is a current difference between the two sides of transformer. For this reason, a starlike transformation is carried out to the secondary winding of Y-side current transformer according to the connection mode of d-side primary winding, in order to eliminate the influence of the vector difference and to ensure the correctness of secondary differential protection. Key words: transformer; primary wiring connection mode;