JASM测试方法.docVIP

1。ISTC NT1-PLUS是加在后板上BA18处的。 如加上NT1-PLUS，测试段需要在14或者11前加上10，这样可以多一个对用户终端的测试项目。 参数修改：P1=FF（8块斑子全测） P3=FFFF P5（0）=0 P5（1）=2 测试段：如是ISTC--BAAB：0，1，11，12，13，16，2，3，4，5，6，7，8，14，17，EE 如是ISTC--BABC：0，2，3，4，5，6，7，8，14，15，1，11，12，13，16，17，EE TEST ISTC BOARD Load ‘EYQLKA**’ Set parm: Parm1：Comprises the information about the ISTC-PBAs which should be tested parallel. This parameter is bit orientated and the bits have a high active status (‘0’? no test,’1’? test) 如测位置为7的ISTC，Parm1＝1H， 如测位置为3、4的ISTC，Parm1＝18H Parm2: This parameter comprises the information about the Basic Access,which will be tested. It is bit orientated Bit0 ? Basic Access0 Bit1 ? Basic Access1 : Bit7 ? Basic Access7 and these bits are high active ‘0’ ? no test, ‘1’ ?test = FF (The Basic Accesses 0-7 of ISTC should be tested.) Parm3 = FFFF (for Error limit) Parm5(0): This one controls the number of parallel load channels = 1 one load channel = 2 two load channels = 4 four load channels = 8 eight load channels Parm5(1): This one gives the information whether the xray runs on a crossover or non crossover wired module and about the rack family(J-rack/H rack). bit0 : 0 = non crossover ; 1 = crossover bit1 : 0 = H family ; 1 = J family bit2-F : don’t care Parm5(2) = 1 Double testbus 0 single testbus choose segments: segment0 = Loader segment2 = RAM Test segment3 = EPROM Test segment4 = Timer Test segment5 = OBCI Test segment6 = MHDLC Test segment7 = Miscellaneous Reg.Test segment8 = LT1-Loop Test segment14 = HDLC termination Test segment15 = CBCI Test segment1 = RNGX on segment11 = Load on segment12 = IHPC Test segment13 =