ADAMS对悬架提供的性能分析‘.docVIP

Adams/car的悬架分析（Suspension Analyses），共提供悬架38种性能。对所有悬架均提供： ? Aligning Torque - Steer and Camber Compliance //单位回正力矩的转角或外倾角 ? Camber Angle //外倾角 ? Caster Angle //后倾角 ? Dive Braking/Lift Braking //制动点头/制动抬头 ? Fore-Aft Wheel Center Stiffness //悬架纵向刚度 ? Front-View Swing Arm Length and Angle //前视图（虚拟）摆臂长度和角度 ? Kingpin Inclination Angle //主销内倾角 ? Lateral Force - Deflection, Steer, and Camber Compliance // ? Lift/Squat Acceleration //抬头（一般指启动时前悬架抬升，后悬架压缩） ? Percent Anti-Dive Braking/Percent Anti-Lift Braking //（前悬架）防点头/（后悬架）防抬升 ? Percent Anti-Lift Acceleration/Percent Anti-Squat Acceleration // ? Ride Rate //悬架动刚度 ? Ride Steer //悬架转向性能 ? Roll Camber Coefficient //侧倾轮倾系数（车身侧倾时车轮侧倾角与车身侧倾角的比值） ? Roll Caster Coefficient // ? Roll Center Location //侧倾中心位置 ? Roll Steer //Ride steer is the slope of the steer angle versus the vertical wheel travel curve. Ride steer is the change in steer angle per unit of wheel center vertical deflection due to equal vertical forces at the wheel centers. Positive ride steer implies that the wheels steer to the right, as the wheel centers move upward. ? Side-View Angle // The side-view angle is the wheel carrier side-view rotation angle. It is positive for a clockwise rotation, as seen from the left side of the vehicle. ? Side-View Swing Arm Length and Angle // The swing arm is an imaginary arm extending from the wheels side elevation instant center of rotation to the wheel center. For front suspensions, the sign convention is that when the instant center is behind the wheel center, the swing arm has a positive length. For rear suspensions, the sign convention is the opposite: when the instant center is ahead of the wheel center, the swing arm has a positive length. The angle of the swing arm is the angle it makes to the horizontal. A positive angle for a positive length is when the arm slopes downward from the wheel center. A positive angle for a negative length arm is when the arm slopes upward from the wheel center. ? Suspension Roll