太阳能充电控制器PR1210.pdfVIP

PR1210 12 Volt 10 Amp Regulator FOR LIQUID ELECTROLYTE LEAD ACID BATTERIES PP SS LL � AA CC SS II A simple two stage regulator for charging liquid electrolyte lead acid batteries from MM NN AA OO TTRR photovoltaic panels. It uses a rugged power mosfet and switches on the negative side. � � INSTALLATION � HOW THE REGULATOR WORKS Mount the regulator by the holes in the terminal block. The regulator works like an intelligent switch In hot or enclosed spaces, allow 1 cm space behind the between the BAT- terminal and the SOL- terminal. regulator. Connect a wire from the positive battery Charge current flows into the battery until the terminal to the Battery positive (BAT+) terminal. battery voltage rises to the boost maximum (14.6 V). Connect another wire from the negative battery The regulator now switches to float mode. The terminal to the Battery negative (BAT-) terminal. current is switched off and the battery voltage slowly Connect a third wire between the negative side of the falls. When the battery voltage drops below the float solar panel and the Solar negative (SOL-) terminal. cut in voltage (13.4 V), the current is switched on Connect the solar panel positive to the positive again. The charge current continu