标准机械设备安装检验程序.docVIP

XXXXXX FIELD DEVELOPMENT PROJECT COSIGN DISCIPLINE SIGNATURE DATE INSPECTION PROCEDURE FOR MECHANICAL FACILITIES INSTALLTION PAGE X OF X REV. DATE DESCRIPTION BY CH ‘K. APPRO. CLIENT INSPECTION PROCEDURE FOR MECHANICAL FACILITIES INSTALLATION OFFSHORE OIL ENGINEERING CO.,LTD. CNOOC DOCUMENT NO. REV. CERTIFI. NO. DOC-XXXXXX 0 XXXXX CONTENTS SCOPE REFERENCE STANDARDS PERSONNEL QUALIFICATION INSPECTION EQUIPMENT INSPECTION PROCEDURE ACCEPTANCE STANDARDS INSPECTION REPORTS 1.0 SCOPE This procedure covers the methods, techniques and acceptance standards for mechanical facilities installation inspection of XXXXXX project. 2.0 REFERENCE STANDARD Client’s Specification API RP 14C latest edition OSHA SPEC XXXXXX 3.0 PERSONNEL QUALIFICATION Personnel performing this inspection shall be trained for using the gauge of mechanical facilities installation inspection. (gradienter, etc.) 4.0 INSPECTION EQUIPMENT Inspection Equipment Tape Steel tape should be appliedd to measure the location size of equipment. Dial guage should be applied to check parallel alignment of coupling ends and shaft centers. 4.2 Periodic Calibration All equipment mentioned above shall be periodically calibrated by a qualified and recognized test authority. 5.0 INSPECTION PROCEDURE 5.1 INSPECTION ITEMS The following inspections shall be conducted: a. Receiving inspection for equipment b. Foundation inspection. c. Alignment inspection of equipment. d. Alignment inspection of pumps and other rotating machinery. e. Inspection of assembly of inner parts. f. Inspection of filling material. 5.2 INSPECTION PROCEDURES AND STANDARDS 5.2.1 All inspection/test equipment and instrument shall be calibrated. 5.2.2 Foundation inspection Confirm that the beams or floors have been fabricated and finished correctly to assure the sufficient installation of equipment. 5.2.3 Inspection of stationary equipment 5.2.3.1 Inspection item Pe