二次冷轧工艺对含钒钛CGO钢组织与磁性能的影响.pdfVIP

二次冷轧工艺对含钒钛CGO 钢组织和磁性能的影响 1 ）2 ） 2) 2) 2) 1 ） 王新宇 项利 张晨 仇圣桃 赵俊学 1） 西安建筑科技大学冶金学院，西安 710055 2) 钢铁研究总院连铸技术国家工程研究中心，北京 100081 摘要 实验室模拟TSCR 流程试制了较高钒钛含量的普通取向硅钢，并研究了不同二次冷轧工艺对组织和磁性能的影响。结 果表明：二次冷轧压下率较小时在纤维组织中夹杂着形变晶粒（横向组织更加明显），随着压下率增加，全部转变为纤维组 织；在 840℃中间退火、600℃回复退火和 1210℃最终高温退火的实验室条件下，最佳的一次冷轧压下率为 71.7%，二次冷 轧压下率为59.7%，最终成品可发生完善的二次再结晶，成品磁性能P17 达到1.049W/kg，B8 达到1.950T。 关键词 薄板坯连铸连轧 普通取向硅钢 组织 二次冷轧 钒钛 Effect of Double Cold Rolling on Magnetic property and Microstructure of Grain Orient Silicon Steel ） ） ） Wang Xinyu1 2 Xiang li2) Zhang chen2) Qiu Shengtao2) Zhao Junxue1 1) School of Metallurgy, Xi’an University of Architecture and Technology, Xi’an,710055, China 2) National Engineering Research Center of Continuous Casting Technology, China Iron and Steel Research Institute Group, Beijing,100081, China Abstract Effect of double cold rolling on magnetic property and microstructure of grain orient silicon steel with high content of V and Ti produced by TSCR process were researched.The results show that there were deformed elongate grains in the fibrous structure when the double cold rolling ratio was low(especially in the transverse structure).When the middle annealing temperature is 840℃,the recovery temperature were 875℃ and the final annealing temperature were fixed at 1210 ℃, the best first rolling ratio was 71.7% and the best double rolling ratio was 59.7%.With these experimental conditions, the secondary recrystallization of samples were impeccable and the magnetic property were better. Key words thin slab cast rolling(TSCR); grain oriented silicon steel; microstructure; double cold rolling; V and Ti 1 前言 取向硅钢是具有高（110）001取向的3%Si-Fe 软磁合金，它在轧制方向表现出优异的