土木本科毕业设计计算书-江苏扬州某办公楼设计.docVIP

毕业设计（论文）报告 设计题目XX办公楼设计 XX学院（系）XX专业 学号 学生姓名 指导老师 起讫日期 设计地点 XX办公楼设计 姓名：XX 学号：XX 指导老师：XX 摘要 本工程位于扬州市区，采用钢筋混凝土框架结构，主体结构共五层，各层层高均为3.3m。建筑长54.6m，宽16.8m，高16.5m，总建筑面积4586.4m2。 在此次毕设中，首先进行了结构方案布置，初步确定框架梁、柱、板的尺寸，完成承受荷载的计算，然后对楼盖和屋盖进行设计计算。然后主要对框架结构中的7轴框架进行了恒活荷载下、风荷载下和地震荷载下的内力计算。在结构内力计算完成，利用Excel对各工况下的内力进行了内力组合，最后找出最不利内力进行梁柱截面的截面设计。该建筑中的楼梯采用现浇板式楼梯，在对楼梯的设计中完成了对平台板，梯段板，平台梁等构件的内力和配筋计算 关键词 框架结构 钢筋混凝土 结构设计 Frame Structure Design Of in Yangzhou, Jiangsu Student：XX Number:XX Supervision：XX Abstract The project islocated in Yangzhou city. It is a reinforced concrete frame structure, which has six stories. Each storey is 3.3m high.The length is 54.6 m,width 16.8 m,height 16.5 m,total construction area 4586.4 m2. In this graduation design,I started with a layout of the program. Then I worked out the Withstand loads. When the array of the structure is determined, firstly do the roof design.Secondly,I calculate the internal force of the frame under the vertical loads (dead load and live load) and the wind load, also the seismic force. After computing the internal force under all sorts of loads, the combination of internal force can be made by using the Excel software, whose purpose is to find one or several sets of the most adverse internal force of members. Then I make out the cross-section design of beams and columns. Slab stairs is used in this structure.The design of the stairs includes calculating the internal force and reinforcing such components as landing slab, step board and landing girder.At last, I designed the independent foundation under column in the design. Then, the results is checked by software PKPM, including analyzing the causes of those differences between them. There are 10 construction drawings based on the calculation results in all. Keywords：Frame Construction,Reinforced concrete,Structure Design目录 1.1工程概况 6 1.1.1工程名称 6 1.1.2 建设地点 6 1.2 建筑设计资料 6 1.3 基本数据 6 1.3.1 地质资料 6 1.3.2 水文条件 6 1.3.3 抗震要求 6 1.3.4 气象条件 6 2.1结构选型 7 2.2 结构布置 7 2.3 初估截面尺寸 7 2.3.1 框架梁