毕业设计（论文）-锐意车工具箱盖双型腔注射模模具设计【完整图纸】.doc

摘要 该论文介绍了塑件汽车工具箱盖双型腔注射模模具的成型工艺，同时说明模具成型结构对塑件质量所带来的影响。浇注系统、顶出机构、模具成型部分和总装结构的设计，构成了本文的主体，而浇注系统中主流道以及浇口位置的合理布局又是其中重点。通过对模具结构方案、模具工作过程以及加工注意事项的详细分析与论述，详细说明注塑模的设计程序、设计工艺。对于脱出机构来说，塑件本身的脱出机构并不复杂，在这章中对侧抽芯机构的设计是设计的重点和难点。在设计中采用最常用的斜导柱机构来完成侧抽动作，结构简单，制造和安装方便。 关键词：工具箱 工艺分析 斜导柱 注塑模 侧抽芯机构 全套图纸，加153893706 Abstract The introduction to this text moulds the shaping craft of the tool case lid of an automobile, and the mould shaping structure, to moulding the influence of a quality. Pour the system , carry out the design of the system , mould shaping part and assembly structure, having formed the subject of this text, and pour in the system the rational overall arrangements of main fact , shunting and runner position are the focal point among them . Through to the structure scheme of the mould , working course of the mould and processing the analysing and describing detailedly of the precautions, is it let reader understand whom note mould design program , design craft to try hard. For deviate from organization , because side releases the design of organization , strengthened the complexity designed. To mould’s carry out structure, it is not complex, in the paper the design for core-pulling structure is emphsis and difficulty. In the designing, use inclined push rod structure which used very often to finish the side take action. This Structure is simple, manufacture and installation is convenient. Key word：lid of tool chest technique inclined push rod injection mold core-pulling structure 目 录 摘要 ………………………………………………………………………………………I Abstract …………………………………………………………………………………II 第1章 绪论 ……………………………………………………………………………1 1.1 选题的依据和意义………………………………………………………………1 1.2 本课题在国内外的研究…………………………………………………………1 1.2.1 塑料模具工业的发展状况 …………………………………………………1 1.2.2 塑料模具工业在国内的发展状况 …………………………………………2 1.2.3 存在的问题和差距 …………………………………………………………2 1.3 本课题的发展展望………………………………………………………………2 1.4 毕业设计内容概述………………………………………………………………3 1.5 本章小结…………………………………………………………………………3 第2章 方案分析 ………………………………………………………………………4 2.1 设