机械毕业设计（论文）-XS-Z60A型注塑机液压系统设计【全套图纸】.doc

内容提要 本课题完成g中小型注塑机的液压系统设计。是热塑性制品的成型加工设备，它将颗粒塑料加热熔化后，高压快速注入模腔，经一定时间的保压，冷却后成型为塑料制品。本次设计主要完成了以下设计内容：注射成型原理和理论研究及注射成型工艺过程分析； 型注塑机节能低耗高效的液压系统设计，绘制工作原理图；液压结构设计与绘图。液压缸设计中，缸体与缸盖采用连接方式，活塞杆与活塞螺纹采用组合式结构中的螺纹连接。液压控制装置的结构采用块式集成设计块式，做成通用化的6面体油路块（集成块）。本设计中采用式安装，液压泵实现泵与的连接。 全套图纸，加153893706  Summary The completion of this subject 60g small injection molding machine hydraulic system. Plastic injection molding is a thermoplastic products, processing equipment, it will heat melting plastic particles, high speed injection mold cavity, after some time packing, cool molding for the plastic products. This design was completed for the following design elements: principles andtheoretical study of injection molding and injection molding process analysis; XS-Z60A injection molding machine, low power and highly efficient energy-saving hydraulic system design, schematic drawing of work; hydraulic structure design and drawing. Hydraulic cylinder design, the cylinder block and cylinder head connection with flange, piston rod and piston screw thread used to connect modular structure. The structure of hydraulic control unit integrated with block block design, made of 6-sided universal manifold block (Manifold).The design of hydraulic station design, with horizontally mounted hydraulic pump, hydraulic pump directly mounted on the bracket only mouth, and then rely on the bottom bracket is connected with the floor, and then with the motor associated with the base. The pump and motor connections. Through this design,I had understood the internal structure of the Hydraulic System , and achieved the knowledge which utilizes to the life production practice .  目 录 内容提要 Ⅰ Summary Ⅱ 1 绪 论 1 1.1 设计目的 1 1.2 设计任务书 1 2 工况分析 4 2.1 合摸油缸负载 4 2.2 注射座整体移动油缸负载 4 2.3 注射油缸负载 5 2.4 顶出油缸负载 5 2.5 初算驱动油缸所需的功率 5 3 油缸工作压力和流量的确定 7 3.1 油缸工作压力的确定 7 3.2 油缸几何尺寸的确定 7 3.3 根据确定的油缸直径标准值，计算实际使用的油缸工作压力 8 3.4 根据确定的油缸直径标准值，计算实际使用的油缸所需流量 10 3.5 油缸功率图的绘制 11 4 液压系统方案和工作原理图的拟定 14 4.1制定系统方案 14 4.2 概述 15 4.3 拟定液压系统图 16 4.4 动作过程 17 5 液压元件的