630故障分析(英文版) (version 1).xlsVIP

ErrorSimulationAndSystemReation Sheet1 ClassDefinitionOfFaultPaht RequirementFromFAW CY33X is unlocked / CY33X init error CY33X is in Testmode CY33X internal parity error CY33X internal program flow error CY33X check of inv. YSEL during ON failed short circuit on Low Side to battery short circuit Low Side to High Side FED current level error P0262 P0263 P0261 faultpath cylinder2-specific errors - stop engine faultpath cylinder2-specific warnings faultpath cylinder3-specific errors - stop engine faultpath cylinder3-specific warnings faultpath cylinder4-specific errors - stop engine faultpath cylinder4-specific warnings faultpath cylinder5-specific errors - stop engine faultpath cylinder5-specific warnings faultpath cylinder6-specific errors - stop engine faultpath cylinder6-specific warnings P0564 main relay does not open in time main relay opens too early Multiple state switch1 not plausible error path for main relay 1 Busoff in CAN A Hardware signal error Plausibility check - oil pressure too high P0523 P0522 P0520 P0521 Plausibility check - oil pressure too low Plausibility error between OTS and CTS P0198 P0197 P0195 P0196 Plausibility error OTS temperature above normal 闪码 显示内容 ECU内模数转换监控器故障 电子油门故障 大气压力传感器故障 同时踩下电子油门和制动踏板的故障 预热总是工作 预热开启或关闭的测试故障 预热故障 进气压力传感器故障 蓄电池故障 预热灯故障 水温传感器故障 牵引力调配故障（过快） 压缩测试故障 离合器信号故障 凸轮轴和曲轴传感器信号偏差太大 凸轮轴传感器故障 曲轴转速传感器故障 排气制动阀故障 燃油质量/扭矩转换MAP错误 燃油滤清器中有污垢 燃油滤清器堵塞故障 单个程序启动（SPI）故障 EEPROM故障 导致ECU自动重启的故障 内部供给电压故障 进气温度传感器故障 Bank1（喷油器电源）特殊故障 Bank2（喷油器电源）特殊故障 Chip（芯片）特殊故障 汽缸1特殊故障 汽缸2特殊故障 汽缸3特殊故障 汽缸4特殊故障 非正常工作喷油器数量超标 主继电器或ECU内主继电器1故障 ECU内看门狗电路故障 发动机倒拖故障 电源供给故障 启动测试故障 ECU初使化时关闭测试故障 内部电源（供传感器，执行器。。。）1/2/3故障 故障指示灯故障 ON档故障 ECU内定时处理单元故障 ECU内数据库故障 SPI故障 高压测试故障 燃油计量单元故障 油压压力限制阀故障 油压压力限制阀打开次数过多或时间过长 油轨压力故障 系统油压控制异常 ECU内主继电器2故障 水温超高 启动继电器故障 Energising time exceeds limit of overrun monitoring P0607 Plausibility error in engine speed check positive governor deviation above limit is set to deaktivate misfire detection during runup test P2263 Watch dog switch off path