毕业设计（论文）-孟家沟铁矿选矿厂年处理量为40万吨原矿.docVIP

摘 要 孟家沟铁矿选矿厂年处理量为40万吨原矿，给矿粒度为300～0mm，选厂设计为一次性平地建厂。 孟家沟铁矿主要矿物为磁铁矿，磁36.5%左右，采用单一磁选工艺磁铁矿粒度为0.毫米选用阶段磨矿阶段选别流程。Meng jia gou’s iron capacity for 40 million tons in ore-dressing plant of ore, Feed size for 300 ~ 0mm, The factory is designed for one-time ground. Meng jia gous main mineral as magnetite iron, magnetite, using a single of 36.5% magnetic separation technology Magnetite granularity for 0.1 millimeter, choose stage grinding, stage for process. For 21.96% ore grade. The first section ore grinding-classification process into the first section, overflow magnetic separation products, production rate for 51.00% grade for the recovery of 78.00%; 33.59%, Through concentrated roughers.tousegravity-flotation products, product grade 53.90% for separation, yield, 148.80% 60.62% for recovery, And then again in the second period of separation products for grinding and fine after the second period of separation, develops For product grade magnetic, yield for 55.33% 57.7% and recovery of 144.90%, The second section of fine screen separation products can reach 62.1% and concentrate grade and recovery rate for 25.81%, for 73.00%, sieve under paragraph 3, the product after magnetic separation, for the product grade for 25.00% respondens yield rate, for 72.2%, The third section by section 4 of magnetic separation to concentrate grade and recovery of 64.8%, 24.47%, yield for 72.2%, Final products through heavy magnetic separation, concentrate 66.5% taste, yield for 23.11%, recovery of 80% Key words: dressing magnetic Stage sorting Stage grinding 目 录 摘 要 I Abstract I 第一章 概述 1 1.1 露天铁矿概况 1 1.1.1 矿区地理位置和交通情况 1 1.1.2 地形 气候 1 1.2 矿石性质 1 1.2.1 矿石性质 1 1.2.2 厂址的选择 2 第二章 选别工艺流程 3 选别工艺的确定 3 第三章 破碎流程计算 5 3.1 新建选厂的规模 5 3.1.1 确定破碎车间工作制度 5 3.1.2 计算设备年作业率 5 3.1.3 计算破碎车间生产能力 5 3.2 破碎流程的选择与计算 5 3.2.1 确定破碎短数及各段破碎比 5 3.2.2 计算各段破碎比 6 3.2.3 计算各段产物最大粒度（mm） 6 3.2.4 计算各段破碎机排矿口宽度（mm） 6 3.2.5 确定筛子的筛孔尺寸和筛分效率 6 3.2.6 计算各段产物的矿量及产率 7 3.2.7 破碎数值量流程图： 7 第四章 主厂房流程计算 8 4.1