apache_tomcat_cluster安装说明.docVIP

一、Apache配置 安装apache http server 运行httpd-2.2.20-win32-x86-openssl-0.9.8r.msi 安装完成后，可以修改apache http server 的端口，默认端口为80 打开Apache2.2\conf\httpd.conf文件，如下图，将端口修改为8087 在httpd.conf最后增加 Include C:\Program Files\Apache Software Foundation\Apache2.2\conf\mod_jk.conf，注意路径为apache http server的安装路径。 将mod_jk.conf、perties文件拷贝到conf目录下。注意perties中的worker.list = controller,Tomcat1,Tomcat2中的Tomcat1 Tomcat2需要与tomcat下server.xml下的Engine name=Catalina defaultHost=localhost jvmRoute=Tomcat2对应。 将modules\mod_jk.so拷贝到对应目录下C:\Program Files\Apache Software Foundation\Apache2.2\modules 二、Tomcat的配置 1、server.xml 修改端口号，跟perties中对应 Connector port=8009 protocol=AJP/1.3 enableLookups=false 修改jvmRoute，跟perties中对应 Engine name=Catalina defaultHost=localhost jvmRoute=Tomcat1 修改Cluster节点 Cluster className=org.apache.catalina.ha.tcp.SimpleTcpCluster channelSendOptions=8 Manager className=org.apache.catalina.ha.session.DeltaManager expireSessionsOnShutdown=false notifyListenersOnReplication=true/ Channel className=org.apache.catalina.tribes.group.GroupChannel Membership className=org.apache.catalina.tribes.membership.McastService address= port=45564 frequency=500 dropTime=3000/ Receiver className=org.apache.catalina.tribes.transport.nio.NioReceiver address=auto port=4000 autoBind=100 selectorTimeout=5000 maxThreads=6/ Sender className=org.apache.catalina.tribes.transport.ReplicationTransmitter Transport className=org.apache.catalina.tribes.transport.nio.PooledParallelSender/ /Sender Interceptor className=erceptors.TcpFailureDetector/ Interceptor className=erceptors.MessageDispatch15Interceptor/ /Channel Valve className=org.apache