练习6_轴承座2.ppt

July 30, 1999 练习 8A轴承座 轴承座 问题描述 将上面练习中生成的轴承座模型划分网格。 同时使用自由网格划分和自动扫描功能。 轴承座 1. 进入ANSYS，工作路径为缺省，工作文件名为 “p-block-mesh”。 2. 读入 “p-block.db” 数据库文件或 p-block.db1： Utility Menu File Resume from … Select the “p-block.db” (or the “p-block.db1”) database file, then [OK] Or issue: RESUME,p-block,db (or RESUME,p-block,db1) 3. 进入前处理器并指定单元类型为 SOLID95: Main Menu Preprocessor Element Type Add/Edit/Delete … [Add ...] Choose “Structural Solid” and “Brick 20node 95”, then [OK] [Close] Or issue: /PREP7 ET,1,SOLID95 轴承座 4. 激活智能网格划分器并使用四面体单元自由划分网格: Main Menu Preprocessor MeshTool … Activate “Smart Size” Set Smart Size level to 4 [Mesh] [Pick All] [Close] Or issue: SMRT,4 MSHAPE,1,3D MSHKEY,0 VMESH,ALL 5. 存储划分好网格的模型: Utility Menu File Save as … Enter “p-block-mesh-free.db” as the database name, then [OK] Or issue: SAVE,p-block-mesh-free,db 轴承座 6. 扫描划分模型: 6a. 清除自由网格: Main Menu Preprocessor MeshTool … [Clear] [Pick All] Utility Menu Plot Volumes Or issue: VCLEAR,ALL VPLOT 轴承座 6b.将轴承座基础分成两部分以便用扫描划分网格: Utility Menu WorkPlane Align WP with Keypoints + Pick the three keypoints displayed in the graphics window below, then [OK] Main Menu Preprocessor -Modeling- Operate -Booleans- Divide Volu by WrkPlane + Pick the base volume, then [OK] Utility Menu WorkPlane Display Working Plane Utility Menu Plot Volumes Or issue: KWPLAN,-1, 12, 14, 11 VSBW,7 WPSTYLE VPLOT 轴承座 6c. 对于不能扫描的体激活“tet-mesh”选项: Main Menu Preprocessor -Meshing- Mesh -Volume Sweep- Sweep Opts ... Select “Tet mesh in nonsweepable volumes”, then [OK] Or issue: EXTOPT,VSWE,TETS,ON 6d. 将smartsize打到4并设置总体单元尺寸为0.125，然后扫描划分模型: Main Menu Preprocessor MeshTool … Pick [Set] under Size Controls: Global Set SIZE = 0.125, then [OK] Select “Hex” and “Sweep”, and leave the default “Auto Src/Trg” setting active [Sweep] [Pick All] [Yes] - to mesh volume 6 with tetrahedra elements Or issue: SMRT,2 VSWEEP,ALL 轴承座 6e. 存储划分好的模型: Utility Menu File Save as … Enter “p-block-mesh-sweep.db” as the database nam