金刚石微粉粒度不同检测方法的比较与研究.pdfVIP

　　2004 年 12 月 金刚石与磨料磨具工程 December 2004 　总第 144 期 　第 6 期 Diamond Abrasives Engineering Serial 144 　No 6 ( ) 文章编号 :1006 - 852X 2004 06 - 0050 - 04 金刚石微粉粒度不同检测方法的比较与研究 COMPARISON AND RESEARCH OF DIFFERENT METHOD OF DIAMOND MICROGRITS PARTICLE SIZE ANALYSIS 李 　颖 (河南工业大学 ,河南 ,郑州 450007) Li Ying ( ) Henan University of Technology , Zhengzhou 450007 , China 摘要 :本文分析比较了不同型号激光粒度分析仪测量同一金刚石样品结果的差异。同时还比较了激光粒度仪与沉 降管法对同一样品检测结果的差异。实验发现 , 由于不同型号的激光粒度分析仪设计原理、数据采集方式、算法不同,导 致检测结果有所差别 ;另外 ,不同方法检测结果没有可比性。因此使用激光粒度分析仪检测粉状物料时 ,应注明所使用 的仪器型号。该结论对超硬材料和磨料磨具行业微粉粒度组成检测有重要的参考价值。 关键词 :粒度组成 ;激光粒度仪 ;沉降管法 中图分类号:TQ164 ;TH6 　　　文献标识码 :A Abstract :The same samples are analyzed and compared with laser particle analyzers of different models in experiment. And also , they are analyzed with sedimentation tube and laser particle analyzer. The different results of both model laser particle analyzers are obtained ,and the difference between sedimentation tube and laser particle analyzer are obserued. The reason is due to the difference of the work principle , the way of data processing , gathering the scattered light signals and algorithms of laser particle analyzer. Otherwise , the different results are incommensurability. Therefore , the model must be shown if powder’s particles size is checked by using laser particle analyzers. This conclusion has important significance for powder’s particles size analysis. Key words :laser particle size analyzer ;s