折光镜的操作方法.docVIP

Model型号: Range范围: Minimun division Accuracy精度 Dimension尺寸 Weight重量 折光仪 Part diagram: prism:棱镜 cover plate:盖板 calibration:校准 mirror tube：镜管 eyepiece(adjusting ring of the diopter) :目镜While looking into the eyepiece ,turn the calibration screw until the boundary between the upper blue field and the lower white field meet exactly on the 0. Once complete the instrument is calibrated for your cument amblent room temperature .when working temperature of the room or enviroment (not the sample)changes by more than 5.F,we recommend recablibrating to maintain accuracy and reproducibility.观察目镜，调整校准螺母，调校至上方蓝色区域和下方白色区域对“0”。完成后，仪器就已经适应现场的环境。当室内的工作环境温度或者环境发生变化大于5.F,我们建议重新校准以把保证精度和再现性Basic operation：基本操作 operation is done in essentially the same manner as calibration.open daylight plate,and place 2-3 drops of the liquid sample on the main prism.close the daylight plate so the sample sareas axross the entire surface of the prism withour air bubble or dry spot .allow the sample to rest on the prism for approximately 30 seconds before going to step 2(this allow the sample to adjust to the sample to adjust to the ambinent temperature of the refractometer)该操作和校准时的方法一样。打开日光板，在棱镜上滴2-3滴蒸馏水。关上盖板让试样（蒸馏水）能够穿过整个棱镜面，并且在棱镜表面无气泡，干点等。让蒸馏水在棱镜面停留约30秒。（该步骤是为了让试样能够适应折射计的环境温度） hole daylight plate in the direction of a light source and look into the eyeooiece.you will see a circular filed with graduation down the center (you may have to focus the eyepiece to clearly see the graductions).The upper protion of the field should be blue,while the lower portion should be white. 拿住日光板对准光源方向，通过目镜观察。在环形的区域内你会看到刻度线在中心（你需要注意目镜的刻度线）。上部分应该是蓝色的，而下部分应该是白色的。 take the reading where the boundary line of blue and while across the graduated scale,The scale will provide a direct reading of the Brix concentration.For use with non-sugar solution,see below.Clean the prism carelly using the damp soft cloth.Do not immerse in water.Read warning below carefully before use.读出读数，其值即为蓝线和白线的分界线。该刻度即为Brix的溶度。如果检测非含糖溶液，见如下操作。采用潮湿柔软的布