改卷流程.docVIP

Internal information INSTRUCTION Uppgjord (?ven faktaansvarig om annan) - Prepared (also subject responsible if other) Nr - No. GUC/N/I Liu Tie / Scottie Liu GUC/N/I - 2003-114 Dokansv/Godk - Doc respons/Approved Kontr - Checked Datum - Date Rev File GUC/N/IC Kevin Cheng 2003-08-03 A 2003-114.doc RESIZING SPG VOLUMES 1?Disturbances The Implementation instruction wrote for ZS A HLR, which has HLR redundancy function is activated. Volume resizing takes around 3-6 hours. One reload in the EX-node and two reloads in the SB-node will occur. The change will not influence the traffic handling of the exchange but the SP will be updating for about 1.5 up to 3 hours. Event Yes No Downtime Small system restart in CP ? x ? Large system restart in CP ? x ? Reload with Large system restart ? x ? Initial start with side switch ? x ? Initial load with side switch ? x ? Small system restart in SP ? x ? Reload with system restart in SP x ? 5 min Function change of CP (Method I) ? x ? Function change of CP(Method II) ? x ? Function change of RP ? x ? Function change of SP x? ? CP disturbances ? x ? RP disturbances ? x ? EM disturbances ? x ? SP disturbances x ? 5 min BS disturbances ? X ? Alarms x ? ? Traffic disturbances? ? x ? External contacts interrupt x ? ? 2?REQUIREMENTS? 2.1?Prerequisites The following conditions must apply before this procedure can be completed : - The IOG(s) must be equipped with an Optical Drive (OD). - The function change should take place during low traffic.- This Implementation Instruction is only to be used by experienced personnel with the proper authority.- The CP must be in parallel operation with A side EX and B side SB/WO. - All links between the CP and the SPG(s) must be Working.- Unused old systems should be removed (LASYP, SYSRR). - The SP shall be in parallel operation with both sides WORKING / NORMAL. - The SP is free from major faults when the function change is initiated. - No other ch