7.00T轮辐的模具毕业设计说明书正文.docVIP

摘 要 本毕业设计的课题来源于的题目，主要任务是设计。 本设计主要围绕冲压模具设计展开，设计宗旨为降低生产成本，提高生产效率，提高模具寿命，而且要求操作方便，维修简单。本文设计的采用， 本文对计算，特别是分析计算。 关键词：；；Abstract The design of the subject from Daye manufacture the limited company product requirements, main task is to design production 7.00 T spokes mould. The main contents of this design is about the design of the stamping dies , Its aim at lower the production cost , increasing production efficiency ,lift the molding tool life span and request for operate convenience , fix briefly and easily .  This paper designs the stamping mould adopts single procedure punch die, according to the distribution of the main task of the cutting edge of the hole. This process using cold stamping technology can achieve high processing requirements to obtain good economy. According to the production requirements, manually feed on the edge with positioning pin blank. In order to facilitate operations using elastic mould cost reduce discharging mode stamping and waste from the punch directly under the push of dies.the hole under a way out. . This paper parts processing technology force, a detailed analysis of the working parts of mold design and calculation of the necessary force, especially the blade, and the cutting clearance analysis and calculation, the choice. According to the requirements of auxiliary parts, standardization of choice. Finally the mould processing can achieve business requirements. Keywords: die, Cutting, Cutting clearance, 目 录 摘 要 I Abstract II 绪 论 1 第1章 模具冲压理论基础 4 1.1塑性变形理论基础 4 1.1.1塑性变形的基本概念 4 1.1.2 金属的屈服条件 5 1.1.3 金属塑性变形时的应力应变关系 6 1.2冲压材料 7 1.3冲压变形时板材变形区受力情况分析 9 1.4模具零件加工 12 1.4.1模具零件加工方法 12 1.4.2模具零件的毛坯选择 13 1.4.3模具零件的机械加工 14 1.4.4模具零件常用精加工方法比较 15 第2章 冲压工艺分析 17 2.1 零件分析 17 2.1.1材料 17 2.1.2零件结构 17 2.1.3尺寸精度 18 2.2工艺方案分析 19 2.3工艺方案确定及个人任务 20 第3章 冲压模具总体结构设计 22 3.1模具类型 22 3.2操作与定位方式 22 3.3卸料与出件方式 22 3.4模架类型及精度 22 3.5模具总装图 22 第4章 模具设计工艺计算 24 4.1 冲压力分析计算 24 4.1.1冲压力计算 24 4.1.2 压力中心 26 4.2工作零件刃口尺寸计算 26 4.2.1凸凹模的间隙选择 26 4.2.2刃口尺寸计算 29 4.3零件结构尺寸 32