ACOPOS_Error_Code_CN_贝加莱.pdf

附录 3：ACOPOS 出错代码表 1: 参数 ID 无效Parameter ID invalid 2: 参数不可读 ( 变量不能在该时刻读取) Parameter can not be read (value is not available at the moment) 3: 对只读参数写访问Write access for a read only parameter 4: 对只写参数读访问: Read access for a write only parameter 5: 参数数值无效Value of parameter is invalid (REAL): 变量格式Info(REAL): Value of Parameter 6: 参数数值无效Value of parameter is invalid (UDINT): 变量格式Info(UDINT): Value of Parameter 7: 参数数值无效Value of parameter is invalid (DINT): 变量格式Info(DINT): Value of Parameter 8: 数据块读访问已经初始化Data block read access already initialized 9: 数据块写访问已经初始化Data block write access already initialized 10: 数据块读访问未初始化Data block read access not initialized 11: 数据块写访问未初始化Data block write access not initialized 12: 数据块读访问仍激活 ( 读访问初始化不可能) Data block write access still active (INIT for read access not possible) 13: 数据块写访问仍激活（写访问初始化不可能） Data block read access still active (INIT for write access not possible) 14: 读响应超时Timeout for Read Response 15: 写响应超时Timeout for Write Response 16: 数据块数据段在读已经在最后The Data segment at data block read is already the last 17: 数据块数据段在写已经在最后The Data segment at data block write is already the last 18: 数据块数据段未在读在最后The Data segment at data block read is not yet the last Info(UDINT): 数据块偏移Data block offset 19: 数据段未在写数据块的最后 Info(UDINT): 数据块偏移Data block offset 20: 数据块读后检验和无效Checksum after data block read is invalid 21: 数据块写后检验和无效Checksum after data block write is invalid 22: 参数 ID 在数据块中无效（读数据块）Parameter ID in data block is invalid (data block read) Info(PARID): Parameter ID 23: 参数 ID 在数据块中无效（写数据块）Parameter ID in data block is invalid (data block write) Info(PARID): Parameter ID 24: 在启动状态不允许下载系统模块System module download not allowed in this boot state Info(UINT): Boot state 25: 只在下载后允许立即烧结系统模块Burn system module only allowed immediately after download 26: 在启动状态不允许改变启动状态请求Requested change of boot state is not allowed in this boot state Info