陈进毕业设计.docVIP

南京三江学院 毕 业 论 文 作者： 陈进 学号： A085091003 学系： 三江高职院 专业： 电子信息工程 题目： MIMO系统界面设计与实现 指导者： 王靖（副教授） 2010年12月 南京 毕 业 论 文 中 文 摘 要 无线通信系统为了达到高速率传输，近年来发展了发射端与接收端都使用多单元天线的架构，称之多输入多输出系统（MIMO）。该技术能在不增加带宽的情况下成倍地提高通信系统的容量和频谱利用率，是新一代移动通信系统必须采用的关键技术。在第三代（3G）乃至三代以后（B3G）的移动通信系统中有着广阔的应用前景。本论文从MIMO无线通信系统的基本概念入手，介绍了MIMO系统发展的必要性，分析了它的结构和工作原理，然后从理论上推导了MIMO系统容量的公式，最后应用MATLAB软件对不同发射天线、不同接收天线、不同信噪比下的MIMO系统容量进行计算机仿真。仿真结果正如预期所料。本文的重点是推导MIMO系统容量公式并对它进行仿真验证。 关键词：多输入多输出 信道模型 信道容量 发射天线 接收天线 毕 业 论 文 英 文 摘 要 Title： Multi-input multi-output (MIMO) system interface design and implementation Abstract: Wireless communication system to achieve high speed transmission, in recent years the development the launching end and the receiver all use multiple units of architecture, called the antenna multi-input multi-output (MIMO) system. This technique can without any increase in bandwidth circumstances multiplied communication system capacity and spectral efficiency is a new generation of mobile communication system must be the key technologies used. Among third-generation (3G) and three generations after (B3G) mobile communication system has broad application prospects. This paper from the multiple-input multiple-output (MIMO) wireless communication system the basic concept, this paper introduces the necessity of developing the multiple-input multiple-output (MIMO) system, analyzes its structure and working principle, then theoretically the multiple-input multiple-output (MIMO) system capacity of formulas, finally using software MATLAB for different antenna, different receiving antenna, different SNR multiple-input multiple-output (MIMO) system capacity of computer simulation was conducted. The simulation results as anticipated expected. This paper is focused on the derivation multiple-input multiple-output (MIMO) system capacity formula it and simulation test. Key words: MIMO channel mode