树脂固化制度对非晶浸漆铁芯软磁性能的影响.pdfVIP

工艺·技术·应用 树脂固化制度对非晶浸漆铁芯软磁性能的影响 唐冬冬，刘天成，黄纯波，李山红，李德仁，卢志超 （中国钢研科技集团安泰科技股份有限公司，北京 100081 ） 摘 要：将非晶 Fe Si B 合金带材卷绕铁芯于 663K 保护气氛下保温 90min ，然后依照正交实验法进行浸 80 9 11 漆固化处理，研究了浸漆铁芯的固化制度对其软磁性能的影响。试验结果表明，铁芯浸漆之后其软磁性能恶化， 其中以固化温度影响最大，升温速率次之，固化时间影响最小。当以 3K/min 升温到 393K 并保温 360min 时， 浸漆铁芯具有最优异的软磁性能，这主要与胶液固化收缩内应力有关。此时，1kHz/1T 下损耗增高 20.7% ， 10kHz/1V 的单匝电感减小 2.6% ，磁感应强度B800 （800A/m ）下降7.1%。该研究优化了非晶铁芯的浸漆固化制 度，对其工业批量生产具有指导作用。 关键词：非晶铁芯；浸漆固化；内应力；软磁性能； 中图分类号：TM275 ；TG132.2+71 文献标识码：A 文章编号：1001-3830(2015)02-0025-04 Influence of curing condition of epoxy resin on the soft magnetic properties of impregnated amorphous cores TANG Dong-dong, LIU Tian-cheng, HUANG Chun-bo, LI Shan-hong, LI De-ren, LU Zhi-chao Advanced Technology and Materials Co, Ltd, China Iron and Steel Research Institute Group, Beijing 100081, China Abstract: Fe Si B amorphous alloy wound cores were annealed at 663K in N for 90 minutes, then 80 9 11 2 impregnated and cured based on orthogonal experimental. The effects of curing condition on the soft magnetic properties of the cores thus fabricated were investigated. Experimental results show that, magnetic properties of the cores deteriorated as a result of the curing procedure in which temperature occupied first place, heating rate took the second and length of the curing process came the last. The cores, cured at 393K for 360 minutes at a rate of 3 K/min, exhibited superior magnetic characteristics, i.e. core loss P increased by 20.7%, inductance L decreased by