PowerFlex_变频器调试与故障排除培训资料_LG.pptVIP

PowerFlex 700? 变频器硬件结构 PowerFlex 700 Drive Overview PowerFlex 700 变频器 报警判断及清除 Alarms 一类报警: 只显示一种状态，不会引起变频器停车。 可通过参数259 [Alarm Config 1]更改设置 二类报警: 阻止操作者在未正确设置之前启动变频器。 不能通过参数更改设置 永远使能 Alarms Alarms Alarms Common Drive Alarms Digital input alarms Stop asserted alarms Digital Input Drive Alarms 因数字输入功能定义有冲突引起的报警 三种类型: Dig In ConflictA，数字输入功能冲突 Dig In ConflictB，配置启动输入，未配置停止。或其他功能冲突。 Dig In ConflictC，不止一个物理输入被配置成相同的输入功能。 Digital Input Drive Alarms Digital Input Drive Alarms Digital Input Drive Alarms Forward/Reverse Speed Select 1 Speed Select 2 Speed Select 3 Run Forward Run Reverse Jog Forward Jog Reverse Run Stop Mode B Bus Regulation Mode B Acc2/Dec2 Accel 2 Decel 2 Stop Asserted Drive Alarms Stop Asserted Caused by… Improper Wiring for Start/Stop Possible loss of logic power supply Possible missing jumper for logic common P/S Common Actual stop command is being issued Stop Asserted will generate and Alarm message on the HIM display and cause the STS LED to blink Yellow Causes for Stop Asserted are not listed in the User Manual The Alarm Queue LCD HIM DriveExplorer software DriveExecutive software The LCD HIM Alarm Queue The DriveExplorer Software Alarm Queue The DriveExecutive Software Alarm Queue PowerFlex 700 变频器 故障清除 Faults Faults 变频器输出立即中断 马达自由滑坡停车 故障信息显示在HIM上 Faults Fault condition is latched, requiring fault reset action to clear latched condition. If fault condition still exists after reset, drive will fault again. Additional data on status of drive at time of fault is recorded: Only a single copy of this information Always related to most recent fault When another fault occurs, this data is overwritten with new data Faults Fault Queue 八个故障事件排列 包括故障代码和发生时间。 先进先出(FIFO) 排列 存于非易失性存储器 Fault Queue LCD HIM DriveExplorer software DriveExecutive software The LCD HIM Fault Queue The DriveExplorer Software Fault Queue The DriveExecutive Software Fault Queue Clearing a Fault 引起故障的原因必须查明并解除后，故障才可以清除。 要清除故障可以: 按HIM 上的停止按钮。 或 Click “Clear Fault” in Fault