黄铜_钢扩散复合双金属界面组织与性能.pdfVIP

28 1 Vol . 2 8 No . 1 2 0 0 7 2 TRANSACTIONS OF MATERIALS AND HEAT TREATMENT February 2 00 7 刘德义, 刘世程, 陈汝淑, 王晓峰 ( , 11 028) : , , ; , , , 220MPa; , : ; ; ; : TG14 ;TG15 2 : A : 1009 2 4(2007) Microstructure and mechanical properties of diffusion bonding brasssteel bimetal LIU Deyi, LIU Shicheng, CHEN Rushu, WANG Xiaofeng ( College of Materials Science and Engineering, Dalian Jioatong University, Dalian 11 028, China) Abstract: Brass innercladsteel bimetallic bar was prepared by the process of colddrawn and then diffusion annealing. The effect of diffusion annealing temperature and time on the microstructure, component and bonding strength of the brasssteel interface were examined by scanning electron microscope ( SEM) observation, energy dispersive Xray (EDX) analysis, and compression shear strength test. The results show that the metallurgical bond of brass and steel can be achieved by the process of colddrawn and diffusion annealing; within a certain range of temperature and time, joint area and then bond strength of the interface increase with increasing annealing temperature and duration of time, and the compression shear strength of the interface can reach 220MPa. The element interfacial diffusion is observed and no brittle phase is detected. Key words: brasssteel; bimetal; diffusion bonding; bond strength , [ 1] 12mm 150mm , , , 00- 850 ! , 025- 1 h [2] , , [ 3,4] JEOL JSM 3 0LV (SEM) , - ,