_六安—舒城改建道路施工图设计.doc

毕业设计（论文） 六安—舒城改建道路施工图设计 学 院 南 方 学 院 专 业土木工程（交通土建工程方向） 学 号 学生姓名 指导教师 职 称 副 教 授 摘 要 本设计是六安舒城县内一部分长达六公里的旧道路改造，改造工程按设计时速为30km/h的山岭重丘地区三级道路设计规范进行，全路段共设29个交点，普通桩120个，特殊点桩87个，全程共206个桩，道路全长5998.198 km。该段道路共设29个交点，其中圆曲线半径最小的交点是JD13，其半径为65m，圆曲线半径最大的交点是JD10，其半径为300m，根据相关规范此段道路的停车视距为30m，会车视距要满足不小于60m；该道路全程共设两个变坡点，其桩号分别为K2+010和K3+800,两个竖曲线依次为半径取78000m的凸型竖曲线和半径取61000的凹型竖曲线，全路段纵坡坡度依次为-0.3395771%、-0.8412458%和-0.5098545%；道路行车道宽6.5m，路肩宽0.5m，路基宽6.5+0.5×2=7.5m，其路拱坡度为2%，设计中采用第一类曲线加宽。本次工程中土石方挖方总数量74469.7m3，填方总数量65344.08m3，本桩利用6207.7 m3，填缺数量59136.4m3，挖余数量68262m3。关键词： 平面线形 纵断面 横断面 路基路面 Abstract the design is ShuChengXian luan within the past six kilometers of old road reform, reform, the project design speed of 30 km/h mountains in the high level road design heavy standard, whole section consists of 29, common pile 120, special point pile 87, a total of 206 the pile, the road is a 5998.198 km. When the road consists of 29 intersection, among them round the smallest intersection curve radius is JD13, the radius for 65 m, circular curve radius of the intersection of the largest is JD10, the radius for 300 m, according to the related rules of the road for the parking for 30 m stadia, passing to meet beyond not less than 60 m; The road of the changing slope set up two points, the pile Numbers are K2 + 010 and K3 + 800, two vertical curve radius take 78000 m is in the convex curve radius and vertical take 61000 of the sunken model vertical curve, whole sections of the longitudinal change clearly in order as-0.3395771%, 0.8412458% and 0.5098545%; Road width 6.5 m, road shoulder width 0.5 m, roadbed wide 6.5 + 0.5 x 2 = 7.5 m, the way the arch slope as 2%, applied to the design of the first kind of curve widened. This project conditions, the total number of grade 74469.7 m3, fill the total number of 65344.08 m3, the pile using 6207.7 m3, fill in the number of 59136.4 m3, dig residual quantity 68262 m