机床调整误差对螺旋锥齿轮齿面影响的研究.pdfVIP

1 1 1, 2 1, 3 1. , , 410083 2. , , 42 1008 3. , , 341000 : Denavit- Hartenber g , , , , , : ; ; : ; ; ; ; : T H 161; T G596 : 1004 132X( 2009) 01 0011 04 Research on the Influence of Adjustment Errors of Machine on Tooth Surfaces of Spiral Bevel Gear 1 1 1, 2 1, 3 Yan H ngzhi Chen Shuhan Ming Xingzu Liu Ganhua 1. Centr al S uth Univer sity, Changsha, 410083 2. Hunan University f T echn l gy, Zhuzh u, Hunan, 421008 3. Jiangx i U niversity f Science and Techn l gy, Ganzh u, Jiangxi, 34 1000 Abstract: Acc rding t the f rming pr cessing principle f hyp id gear and the Denavit- Harten berg h m gene us transf rmati n matrix , the equati n f hyp id gear c nvex surface w as established, and the surface s gridding w as divided. T he s luti n m del f t th surface err rs w as pr p sed. Fi nally , acc r ding t the actual pr cessing par ameters, the difference surfaces w ere simulated w hen each adjustment parameter w as perturbed. T he r esults sh w that the vertical t l p siti n and the t th pr file angle are quite sensitive t the surface err rs f the neighb rh d f surface c ne and small end. T he h riz ntal t l p siti n and a level w heel p siti n are quite sensitive t the surface err rs f the neighb rh d f r t c ne and big end. T he w heel blank setting angle is quite sensitive t the sur face err rs f the neighb rh d f surface c ne and big end. Key words: machine adjustment err r; f rming; hyp id gear; t th surface err r; analy sis 0 引言 , 1 成形法加工大轮齿面理论方程的建立