海外工程脚手架搭设拆除施工方案范本.docVIP

METHOD STATEMENT FOR SCAFFOLD ERECTIOIN DISMANTLING INTRODUCTION : This procedure highlights the MMG work procedure for the erection dismantling of scaffolds. Execution of the work shall be in accordance with relevant project specifications REFERENCES : ANSI A10.8 : Scaffolding Safety Requirements ANSI A14.2 : Ladders, Portable Safety Metal Requirements ASTM A53 : Standard Specification for Pipe, Steel, Black Hot Dipped Zinc Coated, Welded Seamless ASTM A123 : Standard Specification for Zinc (Hot-dipped Galvanized) Coating on Iron Steel Products ASTM A500 : Standard Specification for Cold-Formed Welded Seamless Carbon Steel Structural Tubing in Rounds Shapes BS 1139 Part 1 Section 1.1 : Specification for Steel Tube BS 1139 Part 2 Section 2.1 : Specification for Steel Couplers, Loose Spigots and Base Plates for Use in Tubular Scaffolds BS 2482 : Specification for Timber Scaffold Boards OSHA 1910.28 : Safety Requirements for Scaffoldings OSHA 1910.29 : Manually Propelled Mobile Ladder Stands Scaffolds (Towers) OSHA 1915.159 : PERSONAL Fall Arrest /systems (PFAS) Saudi Kayan Safety Procedures Manual MMG Safety and Loss Prevention Program RESPONSIBILITY : Scaffolding Superintendent / Supervisor The scaffolding superintendent/supervisor is responsible in overseeing overall scaffolding works in the project. He shall ensure that all scaffold foreman and builders/erectors are properly trained and comply with the requirements of this procedure and Safety Manual. He shall ensure that all work permits were secure before the start of the job. Scaffolding Inspector The scaffolding inspector shall inspect all scaffolds and ensure that these are safe to use and fully comply with relevant specifications and standards. Scaffolding Engineer The scaffolding Engineer shall be responsible for the design and approval of all specialty scaffolds above 12 meters in height and inspection thereof. Safety Supervisor The