LED恒流驱动电路研究与设计.pdfVIP

28 3 Vol.28 No. 3 2011 3 MICROELECTRONICS COMPUTER March 2011 LE 辛晓宁, 陈丽丽 ( , 110870) : 基于CSMC 0. 5m BC 工艺给出LE 恒流驱动电路. 利用 MOS 管饱和区恒流特性以及电流负反馈结 , 给出三种恒流驱动方案. 比较三种方案的恒流工作电压, 确立最终结 . 采用的方案能够有效降低恒流工作电 压并实现利用外接电阻控制恒流输出的大小, 驱动电流范围为14. 5mA 到91.5mA.驱动电流可以通过外接PWM 数字信号实现输出使能控制, 控制响应时间为7ns. 可用于LE 显示屏. 通过 Hspice 软件进行仿真, 5V 的电源电 压波动 10% 时驱动电流波动小于1. 85%.环境温度由25 变化到85 时驱动电流变化2. 14%. 外接电压由0V 变化到5V, 此时的驱动电流变化小于5.5%. 当驱动电流为91. 5mA 时, 恒流工作电压仅为0.38V. : LE 显示; 恒流驱动;低恒流工作电压 : T N432 : A : 1000- 7180( 2011)03- 0126- 04 Research and Design of Constant Current LED Driver Circuit XIN Xiaoning, CHEN Lili (School of Information Science Engineering, Shenyang University of Technology, Shenyang 110870, China) Abstract: Constant current LE driver circuit was designed based on CSMC 0. 5m BC process. T hree methods were given for the constant current driver used of MOS saturation constant and current negative feedback structure. Compared the operating voltage of constant current final structure was established. It can effectively reduce the op erating voltage and control the current by external resistor and this can be used for LE display. T he driving current range of 14. 5mA to 91. 5mA and it can be enable controlled by the external PWM signal with 7ns respond time. Simulated by Hspice software ,the driving currents variance can be controlled within 1.85% when the 5V supply voltage change in 10% and it changed 2. 14% when ambient temperature changed from 25 to 85 . riving current changed less than 5.5% when external voltage varied form 0V to 5V. T he operating voltage achieved only 0.38V when the current was 91. 5mA. Key words: LE dispaly; constant cu