合肥天然气钢管化学成分.docVIP

合肥天然气钢管化学成分 天然气钢管销售处合肥鲁联（05515233868 There is a new enquiry for 4500Tons Steel Tubes for the production of CNG cylinders according to below specs: （4500吨天然气钢管） 1. Material Specs: 原材料规格 a) grade: 34CrMo4 or DIN 1.7220 等级： b) Steel Type: According to ISO 9890-1 Table 2,3 and 5 钢材型号 c) Steel Standard: DIN EN 10263; DIN EN 10083; DIN EN 10132; DIN EN 10250; DIN EN 10297 钢材标准 d) The properties of Steel should not be dependent to its age 钢铁特性不能依靠年龄（我的理解是钢铁特性不能因为使用年数而下降） e) Tube should be produced by seamless process 钢管必须是无缝工艺加工 f) Tubes must be suitable for hot spinning and forming ability 钢管必须适应热旋压 ? 2. Chemical Composition: 化学成分 Composition C Mn Si Cr Mo For ?950 Mpa For 950???1100Mpa P S P S %? Max. 0.37 0.9 0.4 1.2 0.30 0.02 0.02 0.02 0.01 %? Min. 0.3 0.6 0.1 0.9 0.15 - - - - ? P+S0.03 P+S0.025 ? 3- Physical Properties: 物质特性 a) Outside Diameter: 356 mm ± 1% 外径 b) Wall Thickness: 7.4 mm 壁厚 c) Straightness: 2 mm per Meter 笔直误差 ?d) Out of Round: The max and min outside diameter at the same cross section shall not exceed 1% of diameter 同一个切面 最大和最小的外径差不能超过1% e) Internal and External surface of tube shall be free from defects 钢管的内部和表面不能有瑕疵 ? 4- Mechanical Properties (after Heat Treatment) : 机械特性（热处理以后） a) Tensile Strength: 900 to 1100 Mpa 抗张强度 b) Yield Strength:850 Mpa 抗屈强度 c) Impact: Value at -50° C24J/cm2 (According to ISO 148) 碰撞 按照ISO 148 ???????????????????? when width of test piece is 3-5mm (according to ISO 9809-1, table 5) 当测试面是3-5MM时 依照ISO 9809-1, table 5 d) Elongation: ?14% 延伸率 e) Hardness: 300±30 HB 硬度 f) All the tests and sampling must be performed according to ISO 9809-1 所有的测试和试验样品必须依照ISO 9809-1来执行