2012上海交大钢筋溷凝土环形截面构件的统一破坏模型.pdfVIP

46 1 上 海 交 通 大 学 学 报 Vol. 46 No. 1 2012 1 JOURNAL OF SH ANGH AI JIAOT ONG UNIVERSIT Y Jan. 2012 : 1006-246 ( 2012) 01-0152-06 骆华勋, 刘西拉 ( , 200240) : 在Nielsen 模型基础上, 引入钢筋的销栓作用, 并考虑混 土的抗剪承载力, 建立了钢筋混 土环形截面构件在拉压弯剪和扭复合作用下的统一破坏模型. 同时, 将所建模型与原Nielsen 模型的理论解及现有环形截面构件的实验数据进行对比. 结果表明, 所建模型的计算结果更接近于 实际情况, 其在环形截面构件设计及计算中具有较好的适用性. : 钢筋混 土; 销栓作用; 屈服准则; 环形截面 : T U 3 5 : A Unified Failure Model on t he Reinforced Concrete Members wit h Annular Section L UOH ua-x un, L I U X i-la ( Department of Civil Engineering, Shanghai Jiaotong U niversity, Shanghai 200240, China) Abstract: Reinforced concrete structural members w ith annular section are commonly used in concrete chimneys, concrete pipes and elevated w ater tanks, as w ell as in large bridge columns and offshore plat- forms. So it is very necessary to study the mechanism of reinforced concrete annular section structures sub- jected to complex force combination. Based on traditional Nielsen model, a unified failure model on rein- forced concrete members w ith annular section under combined forces of tension, compression, bending, shear and torsion w as formed. T he advantages of this model are to consider the dow el actions of the rein- forcements and reasonably to consider the shear carrying capacity of concrete, w hich makes the calculation results more close to the practical situations. T hen, the theoretical results of this model are compared w ith Nielsen model and a series of experimental results of annular section members. T he comparison verifies that the new model is feasible for the design and calculation of annular section members. Key words: reinforced concrete; dow el action; failure cr