c8051f040的比较器程序.pdfVIP

// // F04x_Comparator0_ResetSource.c // // Copyright 2006 Silicon Laboratories, Inc. // // // Program Description: // // Silicon Laboratories MCUs can use different mechanisms to reset the device. // // This software shows the necessary configuration to use Comparator0 as // a reset source. The code executes the initialization routines and then // spins in an infinite while() loop. If the button on P1.6 (on the target // board) is pressed, then the comparators postive input (CP0+) input will drop // below the comparators negative input (CP0-). When this happens, // Comparator0 will cause the device to be reset. // // When the code is waiting for the button to be pressed, the LED is on. // // Upon every device reset, the code checks the RSTSRC register to determine // if the last reset was due to a comparator reset. If it was a // comparator reset, the code will blink the LED constantly. // // How To Test: // // 1) Compile and download code to a F04x target board // 2) On the target board, connect P2.6 to P3.7 and P2.7 to P1.6 // 3) Run the code and verify that the LED is on // 4) Press the P3.7 switch (this causes a comparator reset) // 5) Verify that the LED is blinking // // // FID: 04X000003 // Target: C8051F04x // Tool chain: Keil C51 7.50 / Keil EVAL C51 // Command Line: None // // // Release 1.0 // -Initial Revision (GP) // -17 MAY 2006 // // // Include Files // #include c8051F040.h // // Global Constants // #define SYSCLK // Clock speed in Hz #define COMPARATOR_SETTLE 10 // Settle time in us sbit LED = P1^6; // Green Led sbit SWITCH = P3^7; // Push-button switch on board // // Function Prototypes // void OSCILLATOR_Init (void); // Configure the system clock void PORT_Init (void); // Configure the Crossbar and GPIO void Comparator0_Init (void); // Conf