Design of drawing straightening machine for rollforming of Ushaped steel.pdfVIP

Advanced Materials Research Vols. 538-541 (2012) pp 1213-1216 f f2012) Trans Tech Publications, Switzerland ^gi:J0.4028//AMR.538-54L1213 Design of drawing straightening machine for roll-forming of U-shaped steel Wang hui-feng^, Han jing-tao, Liu jing, Zhang yong-jun^ School of Material Science and Engineering, University of Science and Technology Beijing %anghuifeng@126.com, hanjt@, °llujlng@, zhangyj@ Key Words : Roll-forming process, drawing die, straightening, U-shaped steel Abstract: The cold-roll-formed profiles usually defects such as bow , camber , twist , edge wave , comer buckling as well as edge cracking , and splitting . Straightening is use d as the later part of working puicedure in order t o eliminate these defect s and improve the quality of the fma l profile . A drawing •iriightening machine is designed to achieve the purposes of the U-shaped steel straightening . In the ilesign coefiBcient of friction, forming speed, roll speed, methods to minimize defects . introduction The roll-forming proces s is a method that raw materials such as hot rolled or cold rolled steel pass througli drawing, stamping, bending or roll bending machine process at room temperature, in this way , a • ;iiiety of hot-rolled thin-walled profiles that hot rolling could not produce can be processed . Roll-formed steel is an economic cross-section steel which ha s reasonable cross-section, high strength, light weight, hiyh material availability and is widely used in automotive, aerospace, construction and other industries [ 1 ] There are many defects in roll-formed profiles such as bow , camber , twist , edge wave , comer buckling as well a s edge cracking , and splitting