fluent噪声分析案例.pdf

Tutorial: Modeling Flow-Induced (Aeroacoustic) Noise Problems Using FLUENT Introduction This tutorial demonstrates how to model 2D turbulent flow across a circular cylinder using large eddy simulation (LES) and compute flow-induced (aeroacoustic) noise using FLUENT’s acoustics model. You will learn how to: • Perform a 2D large eddy simulation. • Set parameters for an aeroacoustic calculation. • Save acoustic source data for an acoustic calculation. • Calculate acoustic pressure signals. • Postprocess aeroacoustic results. Prerequisites This tutorial assumes that you are familiar with the FLUENT interface and that you have a good understanding of basic setup and solution procedures. Some steps will not be shown explicitly. In this tutorial you will use the acoustics model. If you have not used this feature before, first read Chapter 21, Predicting Aerodynamically Generated Noise, of the FLUENT 6.2 User’s Guide c Fluent Inc. May 11, 2005 1 Modeling Flow-Induced (Aeroacoustic) Noise Problems Using FLUENT Problem Description The problem considers turbulent air flow over a 2D circular cylinder at a free stream ve- locity (U) of 69.2 m/s. The cylinder diameter (D) is 1.9 cm. The Reynolds number based on the diameter is 90,000. The computational domain (Figure 1) extends 5D upstream and 20D downstream of the cylinder. U = 69.2 m/s D = 1.9 cm Figure 1: Computational Domain Preparation 1. Copy the file cylinder2d.msh to your working directory. 2. Start the 2D version of FLUENT. Approximately 2.5 hours of CPU time is required to complete this tutorial. If you are