压力蒸汽灭菌装备质量控制检测标准与检测装置研发.pdfVIP

学术论著 中国医学装备2013年6月第10卷第6期 China Medical Equipment 2013 June Vol.10 NO.6 压力蒸汽灭菌装备 质量控制检测标准与检测装置研发* ① ① ① ② ① 张 鹏 荆 斌 陈文霞 李 杰 唐剑飞 [文章编号] 1672-8270(2013)06-0014-03 [中图分类号] R197.39 [文献标识码] A [摘要] 目的： 论证、对比现行国内外热力灭菌设备检测校准规范，研究核验医用热力灭菌设备 温度测量控制仪器在线校准测量方法。方法：通过研究典型医用热力灭菌设备检测装置的准确性 和可靠性，评估核验医用热力灭菌设备温度测量技术标准。结果：完成“医用热力灭菌设备温度 计校准规范”实验验证，实验验证医用热力灭菌温度测量控制仪器测量方法和不确定度的评价方 法。结论：提升医用热力灭菌设备温度的检测技术水平，对医用热力学灭菌设备温度计校准具有 重要参考意义。 [关键词] 质量控制；压力灭菌容器；检测标准；评估系统 DOI: 10.3969/J.ISSN.1672-8270.2013.06.004 Pressure steam sterilization equipment quality control testing standards and testing device development/ZHANG Peng, JING Bin, CHEN Wen-xia, et al// China Medical Equipment,2013,10(6):14-16. 作者简介 [Abstract] Objective: This paper focuses on the current domestic and international comparison 张鹏,男,(1971- ), of calibration specification for testing heat sterilization equipment demonstration, verification 本科学历,高级工程 of on-line calibration and measurement method for medical heat stress temperature sterilization 师。解放军第307医院 equipment. Methods: The medical thermal temperature sterilization equipment standard was 医学工程科，从事医院 assessed by the study on reliability and accuracy of typical medical sterilization equipment 设备管理的工作。 detection device. Results: The medical sterilization equipment thermometer calibration specification experiment was finished, the medical instrument measurement method and uncertainty evaluation method for measuring the degree of thermal sterilization temperature control were validated. Conclusion: Promote the measurement of medical instrument temperature controller for sterilization equipment, and provide the reference to t