2016 High-Efficiency Single-Input Multiple-Output DC–DC Converter.pdfVIP

886 IEEE TRANSACTIONS ON POWER ELECTRONICS, VOL. 28, NO. 2, FEBRUARY 2013 High-Ef?ciency Single-Input Multiple-Output DC–DC Converter Rong-Jong Wai, Senior Member, IEEE, and Kun-Huai Jheng Abstract—The aim of this study is to develop a high-ef?ciency other words, the generated power of the FC stack also should single-input multiple-output SIMO dc–dc converter. The pro- satisfy the power demand for the BOP. Thus, various voltage posed converter can boost the voltage of a low-voltage input power levels should be required in the power converter of an FC gen- source to a controllable high-voltage dc bus and middle-voltage out- put terminals. The high-voltage dc bus can take as the main power eration system. In general, various single-input single-output for a high-voltage dc load or the front terminal of a dc–ac inverter. dc–dc converters with different voltage gains are combined to Moreover, middle-voltage output terminals can supply powers for satisfy the requirement of various voltage levels, so that its sys- individual middle-voltage dc loads or for charging auxiliary power tem control is more complicated and the corresponding cost sources e.g., battery modules . In this study, a coupled-inductor- is more expensive. The motivation of this study is to design based dc–dc converter scheme utilizes only one power switch with the properties of voltage clamping and soft switching, and the cor- a single-input multiple-output SIMO converter for increasing responding device speci?cations are adequately designed. As a re- the conversion ef?ciency and voltage gain, reducing the control sult, the objectives of high-ef?ciency power conversion, high step- complexity, and saving the manufacturing cost. up ratio, and various output voltages with different levels can be Patra et al. [10] presented a SIMO dc–dc converter capable obtained. Some experimental results via a kilowatt-level prototype of generating buck, boost, and inverted