50W隔离型离线式DC DC.pdfVIP

APPLICATION NOTE U-165 - SLUU096 - JUNE 2001 Lisa Dinwoodie Reference Design: Isolated 50 Watt Flyback Converter Using the UCC3809 Primary Side Controller UNITRODE CORPORATION U-165 Reference Design: Isolated 50 Watt Flyback Converter Using the UCC3809 Primary Side Controller By Lisa Dinwoodie ABSTRACT The flyback power stage is a popular choice for single and multiple output dc-to-dc converters at power levels of 150 Watts or less. Without the output inductor required in buck derived topologies, such as the forward or push-pull converter, the component count and cost are reduced. This application note will re- view the design procedure for the power stage and control electronics of a flyback converter. In these iso- lated converters, the error signal from the secondary still needs to cross the isolation boundary to achieve regulation. By using the UC3965 Precision Reference with Low Offset Error Amplifier on the secondary side to drive an optocoupler and the UCC3809 Economy Primary Side Controller on the primary side, a simple and low cost 50 Watt isolated power supply is realized. INTRODUCTION is achieved by using the UCC3809 on the primary side for fixed frequency current mode control and The flyback converter reviewed in this application using the error amplifier and precision reference of note is specifically designed to interface with the the UC3965 on the secondary side. Each of these voltage ranges used in the telecommunications in-