《《IEC 已经检测61item》.xlsVIP

xenalight xenon 24.3 Equipment shall not overbalance when tilted through an angle of 5°in any position of Normal Use, excluding transport. Equipment shall carry a warning notice stating that transport should only be undertaken in a certain position which shall be clearly described in the instructions for use or illustrated on the Equipment. in the position specified for transport, Equipment shall not overbalance when tilted to an angle of 10° b) Equipment specified by the manufacturer as portable equipment with a mass of more than 20kg shall have carrying-handle suitably placed which enable the Equipment to be carried by two or more persons. Expelled parts 25.1 Where expelled parts could constitute a safety hazard protective means shall be provided Suspended masses the safety device shall have safety factors complying with 28.4.2 if equipment can still be sued after failure of suspension means and activation of a safety device, it shall become obvious to the operator that the safety device has been activated. 1) the Total Load shall not exceed the Safe Working Load. 2) where it is unlikely that supporting characteristics will be impaired by wear, corrosion, material fatigue or ageing, the safety factor of all supporting parts shall not be less than 4. 3) where impairment by wear, corrosion, material fatigue or ageing is expected, relevant supporting parts shall have a safety factor not less than 8. 4)where metal having a specific elongation at break of less than 5% is used in supporting components, the safety factors, as given in 2) and 3) above shall be multipled by 1.5 5) sheaves, sprockets, bandwhells and guides shall be so designed and comstructed that the safety factors of this sub-clause of the suspension system shall be maintained for a specified min life till replacement of the ropes, chains and bands. Locations and basic requirements. for Category AP and APG equipment, shall be conform with GB9706.1 37. Marking, Accompanying Documents. for category AP and A