《GSD_V5R15_Lesson01》.ppt

Copyright DASSAULT SYSTEMES 2002 Generative Shape Design Table of Contents (1/4) Introduction to Generative Shape Design p.7 The User Interface p.8 Creating Wireframe Geometry p.10 Creating Wireframe Basic Features p.11 Creating Planes Between other Planes p.12 Creating a Set of Planes p.13 Creating an Extremum p.14 Creating a Polar Extremum p.15 Creating Projected Elements on a Support p.17 Creating a Combined Curve p.18 Creating a Reflect Line p.19 Intersecting Elements p.20 Creating a Curve Parallel on a Support p.21 Creating Circles p.22 Creating Corners p.23 Creating Connect Curves p.25 Creating a Conic p.27 Creating a Spline Curve p.28 Table of Contents (2/4) Creating a Helix p.29 Creating a Spiral p.30 Creating a Spine p.31 Creating a Cornered Polyline p.32 Creating the Boundaries of a Surface p.33 Stacking Command p.34 Working on a Support p.35 Creating Surfaces p.36 Creating an Extruded Surface, a Revolution Surface p.37 Creating a Sphere p.38 Creating an Offset Surface p.39 Creating an Explicit Type Swept Surface p.40 Creating an Implicit Type Swept Surface p.41 Creating an Adaptative Swept Surface p.42 Creating a Fill Surface p.43 Creating a Lofted Surface p.44 Creating a Blend Surface p.45 Extracting an Element p.46 Extracting Multiple Edges p.48 Table of Contents (3/4) Performing Operations on the Geometry p.49 Joining Geometry p.50 Performing a Healing p.53 Smoothing Curves p.55 Restoring Surfaces p.56 Disassembling Wireframe and Surface Elements p.57 Splitting and Trimming p.58 Creating Patterns p.60 Transforming Elements p.61 Creating a Near Element p.62 Creating a Shape Fillet p.63 Creating an Edge Fillet p.65 Creating a Variable Fillet p.66 Creating a Face-to-Face and Tri-tangent Fillet p.67 Extrapolating Elements p.68 Inverting Orientation p.69 Creating Laws p.70