MSK调制解调系统的设计副本毕业论文.doc

MSK调制解调系统的设计 XX （XXXX学院 物理及电信学院 XXX级X班 XX XX AAAAA） 指导老师：XX [摘要] 最小频移键控（MSK）是恒定包络调制技术，它具有相位连续、频带利用率高的特点，是在无线通信领域中很有吸引力的数字调制方式，目前在短波、微波和卫星通信中均被采用。本文研究了最小频移键控系统调制与解调的工作原理，并给出了基于MATLAB软件环境下的程序仿真及simulink下系统的模块搭建实现两种方式的实现。运用m语言进行仿真，主要是依照MSK系统的工作原理绘制出流程图，最后写出程序进行仿真，并给出每一步骤的仿真结果图形。运用simulink进行系统的模块搭建，是将系统分为调制与解调两个子模块，再将这两个子模块连接成整体的MSK系统模块进行仿真。最后给出全系统的仿真运行结果及其分析研究结果。 [关键字]MSK； Matlab；Simulink；调制解调 Simulation of MSK Modulation and Demodulation System XX XX (XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX) Tutor: XXi [Abstract] Minimum Shift Keying (MSK) is a constant envelope modulation techniques, it has a continuous phase, high bandwidth efficiency characteristics, is very attractive in the field of wireless communications, digital modulation, shortwave, microwave and satellite communicationsmedium were used. In this paper, the working principle of minimum shift keying modulation and demodulation, and gives the realization of program simulation and simulink system module in the MATLAB software environment to build in two ways. M language simulation, the main draw a flow chart in accordance with the MSK system works, and finally write the program simulation, and gives each step of the simulation results graphics. Use simulink module of the system construction, the two sub-modules of the system is divided into modulation and demodulation, and then two sub-modules connected into the overall MSK system module for simulation. Finally, the simulation run of the system-wide results and their analysis results. [Key words]MSK; Matlab ;Simulink; Modulation and Demodulation 目录 引言 1 1 方案的论证与选择 3 1.1 基于SystemView的设计 3 1.2 基于Matlab的设计 3 1.3 基于FPGA的设计 3 1.4 方案选择 4 2 MSK信号调制解调原理 5 2.1 MSK的特点 5 2.2 MSK的调制原理 5 2.3 MSK的解调原理 10 2.4 MSK的性能分析 11 3 基于Matlab的MSK调制解调系统的设计 13 3.1 Matlab中的m语言和Simulink简介 13 3.2 运用m语言设计MSK调制解调系统 14 3.2.1运用m语言设计的流程图 14 3.2.2测试结果及分析 15 3.3 运用Simulink设计MSK调制解调系统 18 3.3.1 Simulink MSK调制模块设计 18 3.3.2 Simulink MSK解调模块设计 19 3.3.3 测试波形分析 21 结束语 25 致谢 26 参考文献 27 附录A 英文文献