《CC2430单片机串口测试实验(UART)》.doc

无线龙04协议栈 CC2430单片机串口测试实验（UART） 程序： 1、《main.c》 #define ENABLE_ALL_INTERRUPT() (IEN0 |= 0x80)#define DISABLE_ALL_INTERRUPT() (IEN0 = ~0x80) #includeioCC2430.h #define uchar unsigned char#define uint unsigned int#define BYTE unsigned char extern void UARTxISRopen(void); //开串口接收中断服务函数extern void SET_UART0_ISR(void); //串口中断接收设置函数extern void initUART(void); //初始化函数 main( void ){ uchar temp = 0;  SLEEP = ~0x04; //reset 2:Both oscillators powered up while(!(SLEEP 0x40)); //XOSC is powered up and stable 等待起振  CLKCON = ~0x47; //reset 6:Main clock oscillator select: 32 MHz crystal oscillator  SLEEP |= 0x04; //set 2:Oscillator not selected by OSC bit powered down //先让两个振荡器都起振；等待晶体振荡器起振并稳定； //通过CLKCON的OSC位把主时钟选择32M晶体振荡器； //再让没有被CLKCON的OSC位选择的振荡器停止起振（关RC振荡器）  initUART(); //初始化 UARTxISRopen(); //开串口接收中断函数 ENABLE_ALL_INTERRUPT(); //开全局中断 while(1);} //---------------------------------------------------------------------------- 2、《uart.c》 #includeioCC2430.hunsigned uarttemp; #define ENABLE_ALL_INTERRUPT() (IEN0 |= 0x80) //开全局中断#define DISABLE_ALL_INTERRUPT() (IEN0 = ~0x80)//关全局中断 #define IO_PER_LOC_UART0_AT_PORT0_PIN2345() do { PERCFG = (PERCFG~0x01)|0x00; } while (0) //reste 0:USART0 I/O location: Alternative 1 location //选择USART0为通道1：P0.2345#define uchar unsigned char #define CRYSTAL 0x00#define RC 0x01 #define HIGH_STOP 0x02 //停止位为高电平#define LOW_STOP 0x00 //停止位为低电平 #define CLKSPD (CLKCON 0x07)//32KHZ and 32MHZ crystal oscilliator;32MHZ ticks #define TRANSFER_MSB_FIRST 0x80 //最高位先发送#define TRANSFER_MSB_LAST 0x00 //最高位后发送//LSB（Least Significant Bit），意为最低有效位//MSB（Most Significant Bit），意为最高有效位 #define UART_ENABLE_RECEIVE 0x40 //UART接收使能 #define UART_SETUP(uart,